?? config
字號:
## This file is used for selecting non-standard netcard options, and# need not be modified for typical use.## Drivers are *not* selected in this file, but rather with files# automatically generated during the top-level kernel configuration.## Special options supported, indexed by their 'config' name:## CONFIG_WD80x3 The Western Digital (SMC) WD80x3 driver# WD_SHMEM=xxx Forces the address of the shared memory# WD_no_mapout Don't map out the shared memory (faster, but# your machine may not warm-boot).# CONFIG_NE2000 The NE-[12]000 clone driver.# PACKETBUF_MEMSIZE Allows an extra-large packet buffer to be# used. Usually pointless under Linux.# show_all_SAPROM Show the entire address PROM, not just the# ethernet address, during boot.# rw_bugfix Patch an obscure bug with a version of the 8390.# CONFIG_HPLAN The HP-LAN driver (for 8390-based boards only).# rw_bugfix Fix the same obscure bug.# CONFIG_EL2 The 3c503 EtherLink II driver# EL2_AUI Default to the AUI port instead of the BNC port# no_probe_nonshared_memory Don't probe for programmed-I/O boards.# EL2MEMTEST Test shared memory at boot-time.# CONFIG_PLIP The Crynwr-protocol PL/IP driver# INITIALTIMEOUTFACTOR Timing parameters.# MAXTIMEOUTFACTOR# D_LINK The D-Link DE-600 Portable Ethernet Adaptor.# D_LINK_IO The D-Link I/O address (0x378 == typical)# D_LINK_IRQ The D-Link IRQ number to use (IRQ7 == typical)# D_LINK_DEBUG Enable or disable D-Link debugging# DEPCA The DIGITAL series of AT Ethernet Cards (DE100, DE200)# DEPCA_IRQ Set the desired IRQ (=0, for autoprobe)# DEPCA_DEBUG Set the desired debug level## The following options exist, but cannot be set in this file.# lance.c# LANCE_DMA Change the default DMA to other than DMA5.# 8390.c# NO_PINGPONG Disable ping-pong transmit buffers.# Most drivers also have a *_DEBUG setting that may be adjusted.# The 8390 drivers share the EI_DEBUG settting.# General options for Space.cOPTS = # -DETH0_ADDR=0x300 -DETH0_IRQ=11WD_OPTS = #-DWD_SHMEM=0xDD000EL2_OPTS = #-DEL2_AUINE_OPTS =HP_OPTS =PLIP_OPTS =DEPCA_OPTS = -DDEPCA_IRQ=0 -DDEPCA_DEBUG=1# The following are the only parameters that must be set in this file.DL_OPTS = -DD_LINK_IO=0x378 -DD_LINK_IRQ=7 -UD_LINK_DEBUG
?? 快捷鍵說明
復制代碼
Ctrl + C
搜索代碼
Ctrl + F
全屏模式
F11
切換主題
Ctrl + Shift + D
顯示快捷鍵
?
增大字號
Ctrl + =
減小字號
Ctrl + -