For compile Microwindows for DOS & PACIFIC C you should have the following:=====================================================================1. Microwin 0.87 pre6     - microwindows.censoft.com2. PACIFIC C ver. 7.51    - www.hitech.com or www.freedos.org            You should do the following:----------------------------- EDIT files *.prj to correct paths- copy microwin\src\contrib\pacific\mwin-pct.prj microwin\src\mwin-pct.prj- copy microwin\src\contrib\pacific\mwin-pcw.prj microwin\src\mwin-pcw.prj- copy microwin\src\contrib\pacific\mwin-pcn.prj microwin\src\mwin-pcn.prj- you should check the next:	options | memory model.. | memory model = (*) Large L	options | heap size | = 2048	options | output file type | (*) MS-DOS Executable Type	make | CPP predifined symbols | -DERASEMOVE=1 -DMSDOS=1 -DNONETWORK=1	make | CPP include paths | c:\develop\microwin\src\includeRUN ppd, load project and compile !=====================================================================For NANOXDEMO use -DNONETWORK=1- mwin-pct.prj = test demo- mwin-pcw.prj = mwin demo- mwin-pcn.prj = nanox demo! NOT all demos have been tested.=====================================================================TO COMPILE with PACIFIC C :You === SHOULD == check to include header's files only ONE time.PACIFIC C doesn't check it. If you do include, PACIFIC C may gives quite strange errors.=====================================================================Victor Rogachev <rogach@sut.ru>