/* * Header file with homologenisation(sp?) stuff in. * * Copyright 1999 Jamie Lokier / Pavel Machek /R.J.M. Close, * * Distribute under the terms and conditions of the GPL. */#ifndef HOMOL_H#define HOMOL_H 1unsigned char _S [0xd7];#define homol (_S + 0x86)/* Offsets 0x86 to 0xd6 are actually 0-80 in the homol array.   Lower offsets are in the S array.   homol [0] is the current country code.   homol [80] seems to be set for European countries (look for tbr21). */#define S(x) (*((x) < 0x86 ? _S + (x) : homol + (x) - 0x86))/* Generated from S_base by xS.pl. */#define S_auto_answer_ring_count			_S [0]#define S_ring_count					_S [1]#define S_AT_escape_char				_S [2]#define S_command_termination_char			_S [3]#define S_response_format_char				_S [4]#define S_command_backspace_char			_S [5]#define S_wait_before_dialing				_S [6]#define S_connect_completion_timeout			_S [7]#define S_comma_dial_time				_S [8]#define S_auto_disconnect_delay				_S [10]#define S_DTMF_dial_speed				_S [11]#define S_escape_guard_time				_S [12]#define S_general_options				_S [14]#define S_V24_options					_S [21]#define S_results_options				_S [22]#define S_sleep_mode_timer_1				_S [24]#define S_V34_enable					_S [28]#define S_inactivity_timer				_S [30]#define S_synthetic_ring_volume				_S [32]#define S_synthetic_ring_frequency			_S [33]#define S_data_calling_tone				_S [35]#define S_negotiation_fallback				_S [36]#define S_dial_line_rate				_S [37]#define S_enable_K56flex_settings			_S [38]#define S_auto_rate					_S [42]#define S_auto_mode					_S [43]#define S_LAPM_negotiation_flags			_S [48]#define S_sleep_mode_timer_2				_S [89]#define S_local_phone_status				_S [90]#define S_line_transmit_level				_S [91]#define S_network_codec_type				_S [108]#define S_speaker_enable				_S [55]#define S_speaker_volume				_S [54]#define country_code					homol [0]#define H_pulse_dial_make_time				homol [1]#define H_pulse_dial_break_time				homol [2]#define H_pulse_dial_digit_pattern			homol [3]#define H_DTMF_high_tone_level_ndB			homol [4]#define H_min_DTMF_dial_speed				homol [5]#define H_max_DTMF_dial_speed				homol [6]#define H_call_progress_detection_threshold_ndB		homol [7]#define H_dial_tone_detection_delay			homol [8]#define H_dial_tone_hole_time				homol [9]#define H_ring_count_reset_delay			homol [10]#define H_min_auto_answer_ring_count			homol [11]#define H_max_auto_answer_ring_count			homol [12]#define H_min_ring_signal_period			homol [13]#define H_max_ring_signal_period			homol [14]#define H_min_ring_cadence_on_time			homol [15]#define H_min_ring_cadence_off_time			homol [16]#define H_min_busy_cadence_on_time			homol [17]#define H_max_busy_cadence_on_time			homol [18]#define H_busy_cycles_threshold				homol [19]#define H_min_busy_cadence_off_time			homol [20]#define H_max_busy_cadence_off_time			homol [21]#define H_detect_number_unavailable			homol [22]#define H_answer_tone_validation_time			homol [23]#define H_blacklist_or_delay_flag			homol [24]#define H_max_failure_count_before_blacklist		homol [25]#define H_troubled_call_delay				homol [26]#define H_ineffective_call_delay			homol [27]#define H_erroneous_call_delay				homol [28]#define H_blacklist_duration				homol [29]#define H_overcurrent_sense_validation_time		homol [30]#define H_calling_tone_flag				homol [31]#define H_blind_dial_flag				homol [32]#define H_busy_detect_disable				homol [33]#define H_guard_tone_type				homol [34]#define H_bell_modes_permitted				homol [35]#define H_off_hook_restrictions				homol [36]#define H_shunt_relay_on_time				homol [37]#define H_hook_flash_time				homol [38]#define H_min_blind_dial_pause				homol [39]#define H_max_blind_dial_pause				homol [40]#define H_min_no_answer_timeout				homol [41]#define H_max_no_answer_timeout				homol [42]#define H_min_dial_pause_time				homol [43]#define H_max_dial_pause_time				homol [44]#define H_min_no_carrier_disconnect_time		homol [45]#define H_max_no_carrier_disconnect_time		homol [46]#define H_transmit_level_ndB				homol [47]#define H_dial_modifier_validation			homol [48]#define H_TAD_rx_gain					homol [49]#define H_full_wave_ring_detect				homol [50]#define H_max_failed_attempts_stage_1			homol [51]#define H_max_failed_attempts_anywhere			homol [52]#define H_erronous_call_increment_count			homol [53]#define H_dial_tone_validation_time			homol [54]#define H_detect_busy_tone_during_dial_tone		homol [55]#define H_DTMF_high_low_tone_level_difference_dB	homol [56]#define H_not_local_phone_detection_in_speakerphone	homol [57]#define H_not_pulse_dial_flag				homol [58]#define H_dial_tone_or_call_progress_filter		homol [59]#define H_dial_tone_detection_threshold_dB		homol [60]#define H_disallow_ABCD_dialing				homol [61]#define H_comma_pause_duration_limit			homol [62]#define H_TAD_tx_level_dB				homol [63]#define H_data_or_fax_carrier_rx_threshold_dB		homol [64]#define H_no_dialtone_timeout_with_W_modifier		homol [65]#define H_data_or_fax_answer_detection_threshold_dB	homol [66]#define H_dialtone_level				homol [67]#define H_fax_rx_threshold_dB				homol [68]#define H_disallow_mixed_tone_and_pulse_dial		homol [69]#define H_ringer_impedance_relay_flag			homol [70]#define H_DC_loop_VI_characteristics_relay_flag		homol [71]#define H_DC_loop_limiting_relay_flag			homol [72]#define H_real_complex_impedance_setting		homol [73]#define H_mercury_cioca_MSB_rx_gain			homol [74]#define H_mercury_cioca_LSB_hybrid			homol [75]#define H_mercury_ciocb_MSB_tx_gain			homol [76]#define H_mercury_ciocb_LSB_BOM_control			homol [77]#define H_mercury_ciocb_MSB_tx_gain_in_TAD_mode		homol [78]#define H_mercury_ciocb_MSB_tx_gain_in_FDSP_mode	homol [79]#define H_0xd6						homol [80]#define H_0x7f						homol [0x7f - 0x86]// Should really use the corresponding bytes in the array to// hold the word values.unsigned short S_0x4f, S_0x4b;unsigned short S_0x5d, S_0x61, S_0x64;#endif