Analog to Digital Converter Example Program
===========================================
Project: ADC

This example program shows how to configure and use the A/D Converter
of the following microcontroller:

   * STMicroelectronics ST10F166

After configuring the A/D, the program reads the A/D result and
outputs the converted value using the serial port.


To run this program...

1. Build the project (Project Menu, Build Target)
2. Start the debugger (Debug Menu, Start/Stop Debug Session)
3. View the Serial Window (View Menu, Serial Window #1)
4. View the A/D converter peripheral (Peripheral Menu, A/D Converter)
5. Run the program (Debug Menu, Go)

A debug script (debug.ini) creates buttons that set different 
analog values in A/D channels.  As the program runs, you 
will see the A/D input and output change.

Other buttons create signals that generate sine wave 
or sawtooth patterns as analog inputs.  礦ision3 users may 
enable the built-in Logic Analyzer to view, measure and compare
these input signals graphically.