README: Motorola CPV3060This file contains board-specific information for the Motorola cpv3060target board.  Specifically, this file contains information on any BSPinterface changes from previous software or hardware versions, andcontains caveats that the user must be aware of before using this BSP.Additionally, the target board's reference entry (i.e., cpv3060/target.nr)provides board-specific information necessary to run VxWorks, andshould be read before this BSP is used.-------------------------------------------------------------------------------BSP Version 1.2/3:	This release corrects the BSP Revision number to match WRS	standards.EARLY ACCESS RELEASE (BSP Version 1.2/0.3):	This release fixes a problem with SBRAM sizing in sysLib.c, this	is the only change from version 0.2.EARLY ACCESS RELEASE (BSP Version 1.2/0.2):	This BSP supports the CPV3060.        This is the second release of the BSP for the Motorola CPV3060 board.        It will only work on Tornado 2.0 due to the new FEC END driver being        used in the BSP.  Tornado 1.0.1 is NOT supported!        The following are the changes that have been made to create the 0.2        version of the BSP:            - Upgrade of the FEC driver to WRS END compatibility.            - Make the VPD interface compatible with the current MCG standard              as defined for the MVME2100/2400 BSPs.            - Support auto detection and sizing of SBRAM.  ****************************************************************************  ****    A REQUIREMENT FOR THIS BSP TO WORK IS THE VPD AND SPD SROMS     ****  ****    ON THE BOARD MUST BE PROGRAMMED CORRECTLY!!!!  IF THEY ARE      ****  ****    INCORRECT OR NOT PROGRAMMED, THE BSP WILL NOT RUN.              ****  ****************************************************************************Known problems:1.  MCP750/MCPN750 CompactPCI Backpanel Networking Patch	If the CPV3060 is to be used in a shared memory network with	the MCP750 and possibly the MCPN750, then the MCP750/MCPN750	CompactPCI Backpanel Networking Patch must be installed on	the MCP750 BSP and MCPN750 BSP.	This patch will upgrade the Wind River MCP750 BSP version 1.2/3 	to version 1.2/4. It will upgrade the Wind River MCPN750 BSP	version 1.2/0 to version 1.2/1. It adds support to these BSPs 	when using CompactPCI backpanel networking with the CPV3060 or 	PPMC750 boards.  This patch will only work with the Tornado 2.0	versions of the MCP750 and MCPN750 BSPs from Wind River.	Contact your Motorola SE in order to get this patch./*******************************************************************************	Obtaining Technical Assistance with your Early Access Release*/  For technical assistance please contact your Motorola Systems Engineer.Please have the following information available. SYNOPSIS OF PROBLEM     : PRIMARY AFFECTED MODULE : PRODUCT NAME            : CPV3060 EARLY ACCESS BSPRELEASE                 : 1.2/0.3DATE                    : <Date>REPORTED BY             : <reporter name>    CONTACT             : <contact name>    COMPANY             : <company name>    EMAIL               : <contact email>    ADDRESS             : <contact address>    PHONE               : <contact phone>SYSTEM CONFIGURATION    :     HOST                :     TARGET              :     OTHER PERIPHERALS   : DESCRIPTION OF PROBLEM  : DEMONSTRATION PROCEDURE :  WORK-AROUND / SOLUTION  :