.EV.T1 tek2ps 1.SH NAMEtek2ps \- convert Tektronix\*R 4014 commands to PostScript\*R.SH SYNTAXtek2ps [-p \fIprologfile\fR] [-e] [-s \fIscale] files.SH OPTIONS.IP -pwill use the named prologfile instead of the default (currently/mnt/cmb/msf/tek2ps/tekps.pro)..IP -ewill make `erase' (ESC FF) and `hardcopy' (ESC ETB) synonymous: each willprint the current page and then erase it.  The default will erase withoutprinting or print without erasing..IP -swill scale the entire plot by the per centage specified.  The default mapsthe Tektronix screen to an 8.5 x 11 inch sheet of paper..SH DESCRIPTION.PPTek2ps will take any output designed to be displayed on a Tektronix 4014terminal and translate it to PostScript suitable for sending to any PostScriptdevice.  Some manual editing will probably be required if the PostScriptis to be included in another file.  Tek2ps supports 10 and 12-bit addressingmodes, incremental plots, and defocussed Z axis.  It does.I notsupport crosshair (GIN) mode or special point plot (6-bit greyscale)..PPMultiple.I filesmay be specified; if none are listed standard input is read.  Output is tostandard output..SH EXAMPLEplot -T4014 myplot | tek2ps | lpr -Plw.SH SPECIAL CONSIDERATIONS.PPIf you place multiple screens in a single file, you must either use thehardcopy command followed by an erase to prevent overwriting, or the-e option..SH FILES/mnt/cmb/msf/tek2ps/tekps.pro.SH SEE ALSOgraph(1), plot(1).SH BUGSTek2ps will not support crosshair (GIN) mode or special point plot(6-bit greyscale)..SH AUTHORMichael Fischbein