/*-----------------------------------------------------------*
 * Real-Time Clock Alarm Register (RTCAL)                    *
 *-----------------------------------------------------------*
 * NOTE: The real-time clock alarm (RTCAL) is a 32-bit R/W 	 *
 *       register. When the value of the RTC is equal to the *
 *		 value programmed in the alarm register, a maskable    *
 *		 interrupt is generated 							          *
 *-----------------------------------------------------------*/

#define RTCAL_ALARM  0xFFFFFFFF   



/*--------------------------------------------------------*
 * Periodic Interrupt Status and Control Register (PISCR) *
 *--------------------------------------------------------*/

#define PISCR_PIRQ   0xFF00   /* Periodic Interrupt Request Level */
#define PISCR_PS     0xFF80   /* Periodic Interrupt Status */
#define RESERVED71   0x0078  
#define PISCR_PIE    0x0004   /* Periodic Interrupt Enable */
#define PISCR_PITF   0x0002   /* Periodic Interrupt Timer Freeze */
#define PISCR_PTE    0x0001   /* Periodic Timer Enable */



/*---------------------------------------------------------------*
 * Periodic Interrupt Timer Count (PITC)                         *
 *---------------------------------------------------------------*
 * NOTE: Contains the 16 bits to be loaded in a modulus counter. *
 *       The register is always R/W.          					 *
 *---------------------------------------------------------------*/

#define PITC_PITC   0xFFFF0000
#define RESERVED72  0x0000FFFF



/*----------------------------------------------------------------*
 * Periodic Interrupt Timer Register (PITR)                       *
 *----------------------------------------------------------------*
 * NOTE: A read-only register that shows the current value in the *
 *       periodic interrupt down counter. Reads or writes to 	   *
 *		 this register have no effect on the register or counter    *
 *----------------------------------------------------------------*/

#define PITR_PIT    0xFFFF0000
#define RESERVED73  0x0000FFFF




/*-------------------------------------------------------------------------*
 *                             CLOCKS AND RESET  						         *
 *-------------------------------------------------------------------------*/



/*--------------------------------------*
 * System Clock Control register (SCCR) *
 *--------------------------------------*/

#define RESERVED74   0x80000000
#define SCCR_COM     0x60000000	/* Clock Output Mode */
#define RESERVED75   0x1C000000
#define SCCR_TBS     0x02000000    /* Timebase Source */
#define SCCR_RTDIV   0x01000000    /* RTC Clock Divide */
#define SCCR_RTSEL   0x00800000    /* RTC circuit input source select */
#define SCCR_CRQEN   0x00400000    /* CPM requect enable */
#define SCCR_PRQEN   0x00200000    /* Power management request enable */
#define RESERVED76   0x00180000  
#define SCCR_EBDF    0x00060000    /* CLKOUT frequency */
#define RESERVED77   0x00018000    
#define SCCR_DFSYNC  0x00006000    /* Division factor of SyncCLK */
#define SCCR_DFBRG   0x00001800    /* Division factor of BRGCLK */
#define SCCR_DFNL    0x00000700    /* Division factor low frequency */
#define SCCR_DFNH    0x000000D0    /* Division factor high frequency */
#define RESERVED78   0x0000001F 



/*-----------------------------------------------------*
 * PLL, Low Power, and Reset Control Register (PLPRCR) *
 *-----------------------------------------------------*/  

#define PLPRCR_MF      0xFFF00000   /* Multiplication factor bits */
#define RESERVED79     0x000F0000
#define PLPRCR_SPLSS   0x00008000   /* SPLL lock status sticky bits */
#define PLPRCR_TEXPS   0x00004000   /* TEXP status bit */
#define RESERVED80     0x00002000   
#define PLPRCR_TMIST   0x00001000   /* Timers interrupt status */
#define RESERVED81     0x00000800   
#define PLPRCR_CSRC    0x00000400   /* Clock source bit */
#define PLPRCR_LPM     0x00000300   /* Low power mode select bits */
#define PLPRCR_CSR     0x00000080   /* Checkstop reset enable */
#define PLPRCR_LOLRE   0x00000040   /* Loss of lock reset enable */
#define PLPRCR_FIOPD   0x00000020   /* Force I/O pull-down */
#define RESERVED82     0x0000001F



/*-----------------------------*
 * Reset status register (RSR) *
 *-----------------------------*/

#define RSR_EHRS    0x80	  /* External hard reset status */
#define RSR_ESRS    0x40	  /* External soft reset status */
#define RSR_LLRS    0x20     /* Loss of lock status */
#define RSR_SWRS    0x10     /* Software watchdog reset status */
#define RSR_CSRS    0x08     /* Check stop reset status */
#define RSR_DBHRS   0x04     /* Debug port hard reset status */
#define RSR_DBSRS   0x02     /* Debug port soft reset status */
#define RSR_JTRS    0x01     /* JTAG reset status */




/*-------------------------------------------------------------------------*
 *                     SYSTEM INTEGRATION TIMERS KEYS					         *
 *-------------------------------------------------------------------------*
 * NOTE: Bit masks are not provided for System Integration Timers Keys or  *
 *       Clocks and Reset Keys. A write of 0x55CCAA33 to a key's memory    *
 *       address will change it to the open state. A write of any other    *
 *       data to a key's location will change it to the locked state. At   *
 *       power-on reset, all keys (except for real-time clock related 	   *
 *       registers) are	in the open state.                      		      *
 *-------------------------------------------------------------------------*/															  



/*-------------------------------------------------------------------------*
 *                                  I2C 								            *
 *-------------------------------------------------------------------------*/


/*---------------------------*
 * I2C Mode Register (I2MOD) *
 *---------------------------*/

#define RESERVED83   0xC0
#define I2MOD_REVD   0x20   /* Reverse Data */
#define I2MOD_GCD    0x10   /* General Call Disable */
#define I2MOD_FLT    0x08   /* Clock filter */
#define I2MOD_PDIV   0x06   /* Pre Divider */
#define I2MOD_EN     0x01   /* Enable I2C */



/*------------------------------*
 * I2C Address Register (I2ADD) *
 *------------------------------*/

#define I2ADD_SAD   0xFE    /* Slave Address */
#define RESERVED84  0x01



/*--------------------------*
 * I2C BRG Register (I2BRG) *
 *--------------------------*/

#define I2BRG_DIV   0xFF    /* Division Ratio */



/*------------------------------*
 * I2C Command Register (I2COM) *
 *------------------------------*/

#define I2COM_STR   0x80    /* Start Transmit */
#define RESERVED85  0x7E  
#define I2COM_M/S   0x01    /* Master Slave */		  



/*----------------------------*
 * I2C Event Register (I2CER) *
 *----------------------------*/

#define RESERVED86   0xE0   
#define I2CER_TXE    0x10   /* Tx Error */
#define RESERVED87   0x80
#define I2CER_BSY    0x04   /* Busy Condition */
#define I2CER_TXB    0x02   /* Tx Buffer */
#define I2CER_RXB    0x01   /* Rx Buffer */



/*------------------------------------------------------------------*
 * I2C Mask Register (I2CMR)                                        *
 *------------------------------------------------------------------*
 * NOTE: The I2C mask register is an 8-bit read/write register that * 
 *       has the same bit formats as the I2CER. If a bit in the     *
 *		 I2CMR is 1, the corresponding interupt in the I2CER is       *
 *		 enabled. If the bit is zero, the corresponding interrupt     *
 *		 in the I2CER is marked. This register is cleared at reset.   *
 *              												                 *
 *------------------------------------------------------------------*/

#define RESERVED88   0xE0   
#define I2CMR_TXE    0x10   /* Tx Error */
#define RESERVED89   0x80
#define I2CMR_BSY    0x04   /* Busy Condition */
#define I2CMR_TXB    0x02   /* Tx Buffer */
#define I2CMR_RXB    0x01   /* Rx Buffer */





/*-------------------------------------------------------------------------*
 *                                    DMA 								         *
 *-------------------------------------------------------------------------*/


/*--------------------------------------------------------------------*
 * SDMA Address Register (SDAR) 								   	          *
 *--------------------------------------------------------------------*
 * NOTE: Bit masks are not provived for SDMA Address Register (SDAR). *
 *       The 32-bit read-only SDMA Address Register shows the system  *
 *       address that is accessed during an SDMA bus error. It is	    *
 *       undefined at reset.	                                 	    *
 *--------------------------------------------------------------------*/


 /*-----------------------------*
  * SDMA Status Register (SDSR) *    
  *-----------------------------*/
 
 #define SDSR_SBER    0x80   /* SDMA Channel Bus Error */
 #define SDSR_RINT    0x40   /* Reserved Interrupt */
 #define RESERVED90   0x3C   
 #define SDSR_DSP2    0x02   /* DSP Chain 2 Interrupt */
 #define SDSR_DSP1    0x01   /* DSP Chain 1 Interrupt */
       


/*---------------------------------------------------------------------*
 * SDMA Mask Register (SDMR) 								   	              *
 *---------------------------------------------------------------------*
 * NOTE: Bit masks are not provided for the SDMA Mask Register (SDMR). *
 *       The SDMA Mask Register is an 8-bit read/write register with   *
 *       the same bit format as the SDMA status register. If a bit in  *
 *		 the SDMA mask register is a 1, the corresponding interrupt in   *
 *		 the event register is enabled. If the bit is zero, the		     *
 *		 corresponding interrupt in the event register is masked. This   *
 *		   register is cleared at reset.                           	     *       
 *---------------------------------------------------------------------*/

            

/*-------------------------------*
 * IDMA1 Status Register (IDSR1) *    
 *-------------------------------*/

#define RESERVED91   0xF8
#define IDSR1_OB     0x04   /* Out of buffers */
#define IDSR1_DONE   0x02   /* IDMA transfer done */		
#define IDSR1_AD     0x01   /* Auxiliary done */



/*---------------------------------------------------------------------*
 * IDMA1 Mask Register (IDMR1) 								   	           *
 *---------------------------------------------------------------------*
 * NOTE: Bit masks are not provided for the IDMA1 Mask Register. The   *
 *       IDMA mask register is an 8-bit read/write register with       *
 *       the same bit format as the IDSR. If a bit in the IDMR is a 1, *
 *       the corresponding interrupt in the status register is 		  *
 *       enabled. If the bit is zero, the corresponding interrupt in   *
 *       the status  register is masked. This register is cleared at   *
 *       reset.                                                        *       
 *---------------------------------------------------------------------*/



/*-------------------------------*
 * IDMA2 Status Register (IDSR2) *    
 *-------------------------------*/

#define RESERVED92   0xF8
#define IDSR2_OB     0x04   /* Out of buffers */
#define IDSR2_DONE   0x02   /* IDMA transfer done */		
#define IDSR3_AD     0x01   /* Auxiliary done */



/*----------------------------------------------------------------------*
 * IDMA2 Mask Register (IDMR2) 								   	            *
 *----------------------------------------------------------------------*
 * NOTE: Bit masks are not provided for the IDMA2 Mask Register. The 	*
 *       IDMA mask register is an 8-bit read/write register with        *
 *       the same bit format as the IDSR. If a bit in                   *
 *		   the IDMR is a 1, the corresponding interrupt in                *
 *		   the status register is enabled. If the bit is zero, the	      *
 *		   corresponding interrupt in the status  register is masked.   	*
 *       This register is cleared at reset.                             *       
 *----------------------------------------------------------------------*/




/*-------------------------------------------------------------------------*
 *                          CPM INTERRUPT CONTROL						         *
 *-------------------------------------------------------------------------*/


/*-------------------------------------*