// $Id: beta.CC2420Radio.ieee.802.15.4.MLME.MLME_RX_ENABLE.nc.source,v 1.1 2004/03/09 01:13:28 jpolastre Exp $/*									tab:4 * "Copyright (c) 2000-2003 The Regents of the University  of California.   * All rights reserved. * * Permission to use, copy, modify, and distribute this software and its * documentation for any purpose, without fee, and without written agreement is * hereby granted, provided that the above copyright notice, the following * two paragraphs and the author appear in all copies of this software. *  * IN NO EVENT SHALL THE UNIVERSITY OF CALIFORNIA BE LIABLE TO ANY PARTY FOR * DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT * OF THE USE OF THIS SOFTWARE AND ITS DOCUMENTATION, EVEN IF THE UNIVERSITY OF * CALIFORNIA HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. *  * THE UNIVERSITY OF CALIFORNIA SPECIFICALLY DISCLAIMS ANY WARRANTIES, * INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY * AND FITNESS FOR A PARTICULAR PURPOSE.  THE SOFTWARE PROVIDED HEREUNDER IS * ON AN "AS IS" BASIS, AND THE UNIVERSITY OF CALIFORNIA HAS NO OBLIGATION TO * PROVIDE MAINTENANCE, SUPPORT, UPDATES, ENHANCEMENTS, OR MODIFICATIONS." * * Copyright (c) 2002-2003 Intel Corporation * All rights reserved. * * This file is distributed under the terms in the attached INTEL-LICENSE      * file. If you do not find these files, copies can be found by writing to * Intel Research Berkeley, 2150 Shattuck Avenue, Suite 1300, Berkeley, CA,  * 94704.  Attention:  Intel License Inquiry. *//* * Authors:		Joe Polastre */includes IEEE802154;/** * The MLME-SAP receiver state primitives define how a device can enable or  * disable the receiver at a given time. * * @author Joe Polastre */interface MLME_RX_ENABLE {  /**   * Allows the next higher layer to request that the receiver is   * enabled for a finite period of time   *    * @param DeferPermit TRUE if the receiver enable can be deferred until   *                    during the next superframe if the requested time has   *                    already passed   * @param RxOnTime The number of symbols from the start of the superframe    *                 before the receiver is to be enabled.  The precision    *                 of this value is a minimum of 20 bits.  This parameter    *                 is ignored for nonbeacon-enabled PANs   * @param RxOnDuration The number of symbols for which the receiver    *                     is to be enabled   */  command void request  (                          bool DeferPermit,                          uint32_t RxOnTime,                          uint32_t RxOnDuration                        );  /**   * Reports the results of the attempt to enable the receiver   *   * @param status The status of the receiver enable request   */  event void confirm    (                          IEEE_status status                        );}