##  $Id: README.z85c30,v 1.2 1998/07/15 23:15:49 joel Exp $#Configuration Table Use=======================sDeviceName   The name of this device.deviceType   This field must be SERIAL_Z85C30.pDeviceFns   The device interface control table.  This may be:      + z85c30_fns for interrupt driven IO      + z85c30_fns_polled for polled IOdeviceProbe   This is the address of the routine which probes to see if the device   is present.pDeviceFlow   This field is set to one of the following values:      + NULL for no hardware flow control      + z85c30_flow_RTSCTS for RTS/CTS based flow control      + z85c30_flow_DTRCTS for DTR/CTS based flow controlulMargin    This is currently unused.ulHysteresis    This is currently unused.pDeviceParams    This is set to the default settings.ulCtrlPort1   This field is the address of the control register for this port.ulCtrlPort2   This field is the address of the control register for chip.ulDataPort   This field is the address of the data register for this port.getRegistersetRegister   These follow standard conventions.getDatasetData   These follow standard conventions.ulClock   This is the clock speed of the baud rate clock.   NULL, then the CSR/ACR/X bit mappings shown in the 68681 and 88681   manuals are used.  Otherwise, the board specific baud rate mapping   is used.ulIntVector   This is the interrupt vector number associated with this chip.