?? project.crp
字號:
***************************************************************************
PSDsoft Express Version 8.30
Output of PSD Configurations
***************************************************************************
PROJECT : project DATE : 02/23/2005
DEVICE : uPSD3434E TIME : 15:38:06
***************************************************************************
==== Bus Interface ====
Data Bus Width = 8-Bit
Address/Data Mode = Multiplexed
ALE/AS Signal = Active High
Control Signals = /WR,/RD,/PSEN
Main PSD flash memory will reside in this space at power-up = Program space
Secondary PSD flash memory will reside in this space at power-up = Data space
==== Other Configurations ====
Enable Chip-Select Input(/CSI) = OFF
Enable Standby Voltage Input (PC2) = OFF
Enable Standby-on Indicator (PC4) = OFF
Enable RDY/Busy function (PC3) = OFF
Load Micro-Cell on edge
Security Protection = OFF
==== JTAG Configurations ====
Enable TMS/TCK/TDI/TDO on PC0/PC1/PC5/PC6, respectively = ON
Enables JTAG signal TSTAT on PC3 = OFF
Enables JTAG signal TERR on PC4 = OFF
User Code = FFFFFFFF
==== Flash Sector Protect ====
Flash Sector 0 is unprotected
Flash Sector 1 is unprotected
Flash Sector 2 is unprotected
Flash Sector 3 is unprotected
Flash Sector 4 is unprotected
Flash Sector 5 is unprotected
Flash Sector 6 is unprotected
Flash Sector 7 is unprotected
Flash Boot Sector 0 is unprotected
Flash Boot Sector 1 is unprotected
Flash Boot Sector 2 is unprotected
Flash Boot Sector 3 is unprotected
?? 快捷鍵說明
復制代碼
Ctrl + C
搜索代碼
Ctrl + F
全屏模式
F11
切換主題
Ctrl + Shift + D
顯示快捷鍵
?
增大字號
Ctrl + =
減小字號
Ctrl + -