/* *      dpx2.ifile - for collectless G++ on Bull DPX/2 *	 *      Peter Schauer <Peter.Schauer@regent.e-technik.tu-muenchen.dbp.de> * *      Install this file as $prefix/gcc-lib/dpx2/VERSION/gcc.ifile *	and comment out the lines referring to COLLECT at the top *      of Makefile before building GCC. *	 *      This file has been tested with gcc-2.2.2 on a DPX/2 340 *      running BOS 2.00.45, if it doesn't work for you, stick *      with collect. *	--sjg *//* *	Ifile to link with memory configured at 0. *	BLOCK to an offset that leaves room for many headers ( the value *	here allows for a file header, an outheader, and up to 11 section  *	headers on most systems. *	BIND to an address that excludes page 0 from being mapped. The value *	used for BLOCK should be or'd into this value. Here I'm setting BLOCK *	to 0x200 and BIND to ( 0x100000 | value_used_for(BLOCK) ) *	If you are using shared libraries, watch that you don't overlap the *	address ranges assigned for shared libs. * *	GROUP BIND to a location in the next segment.  Here, the only value *	that you should change (I think) is that within NEXT, which I've set *	to my hardware segment size. You can always use a larger size, but not *	a smaller one. */SECTIONS{	.text BIND(0x100200) BLOCK (0x200) :	{		 /* plenty of room for headers */		*(.init)		*(.text)		_vfork = _fork; /* I got tired of editing peoples sloppy code */		*(.fini)	}	GROUP BIND( NEXT(0x100000) + (ADDR(.text) + (SIZEOF(.text)) % 0x1000)):	{			.data : {				___CTOR_LIST__ = . ; 				. += 4 ;	/* leading NULL */				*(.ctor) 				. += 4 ;	/* trailing NULL */				___DTOR_LIST__ = . ;				. += 4 ;	/* leading NULL */				*(.dtor) 				. += 4 ; 	/* trailing NULL */			 }			.bss : { }	}}