Title: iodemoTarget: PIC18C858Description: A sample project file to be used with HI-TIDE, to demonstrate the     device's input/output capabilities. All I/O ports are used in this    demonstration. The output of Ports A,C,D,E,F,G,H,J & K can be observed via    the LED panels connected to each.Controls:    The IO ports can be configured with any input/output pin configuration. This    is done by entering the configuration on the blue DIP switch (ON=input,     OFF=output). This input/output configuration can be assigned to a port by    pressing the pushbutton associated with that port.    When any pin of a port is set in output mode, the pin will participate in    displaying a test pattern that is generated in software. If any particular pin    is configured as input, that pin will read the value from the corresponding     pin on the blue DIP switch.Interrupts:    This project only uses the change on PORTB interrupt. PORTB is wired to    each of the 8 pushbuttons that are used to update the direction setting    for each port.Connections to the PIC18C858:	LED(red1) [1:7] -> PORTA [0:6]	pushbutton 1 -> PORTB4	LED(red2) [1:8] -> PORTC [0:7]	pushbutton 1 -> PORTB5	LED(green1) [1:8] -> PORTD [0:7]	pushbutton 1 -> PORTB4,PORTB5	LED(green2) [1:8] -> PORTE [0:7]	pushbutton 1 -> PORTB6	LED(blue1) [1:8] -> PORTF [0:7]	pushbutton 1 -> PORTB6,PORTB4	LED(blue2) [1:5] -> PORTG [0:4]	pushbutton 1 -> PORTB6,PORTB5	LED(yellow1) [1:8] -> PORTH [0:7]	pushbutton 1 -> PORTB6,PORTB5,PORTB4	LED(yellow2) [1:4] -> PORTJ [0:3]	LED(yellow2) [5:8] -> PORTK [0:3]	pushbutton 1 -> PORTB7	DIP switch [1:8] -> PORTA,C,D,E,F,G,H,J,K [0:7]