/** ###################################################################
**     THIS BEAN MODULE IS GENERATED BY THE TOOL. DO NOT MODIFY IT.
**     Filename  : PE_Error.H
**     Project   : RTOSDemo
**     Processor : MC9S12DP256BCPV
**     Beantype  : PE_Error
**     Version   : Driver 01.00
**     Compiler  : Metrowerks HC12 C Compiler
**     Date/Time : 13/06/2005, 20:14
**     Abstract  :
**         This bean "PE_Error" contains internal definitions
**         of the error constants.
**     Settings  :
**     Contents  :
**         No public methods
**
**     (c) Copyright UNIS, spol. s r.o. 1997-2002
**     UNIS, spol. s r.o.
**     Jundrovska 33
**     624 00 Brno
**     Czech Republic
**     http      : www.processorexpert.com
**     mail      : info@processorexpert.com
** ###################################################################*/

#ifndef __PE_Error_H
#define __PE_Error_H

#define ERR_OK           0             /* OK */
#define ERR_SPEED        1             /* This device does not work in the active speed mode. */
#define ERR_RANGE        2             /* Parameter out of range. */
#define ERR_VALUE        3             /* Parameter of incorrect value. */
#define ERR_OVERFLOW     4             /* Timer overflow. */
#define ERR_MATH         5             /* Overflow during evaluation. */
#define ERR_ENABLED      6             /* Device is enabled. */
#define ERR_DISABLED     7             /* Device is disabled. */
#define ERR_BUSY         8             /* Device is busy. */
#define ERR_NOTAVAIL     9             /* Requested value or method not available. */
#define ERR_RXEMPTY      10            /* No data in receiver. */
#define ERR_TXFULL       11            /* Transmitter is full. */
#define ERR_BUSOFF       12            /* Bus not available. */
#define ERR_OVERRUN      13            /* Overrun error is detected. */
#define ERR_FRAMING      14            /* Framing error is detected. */
#define ERR_PARITY       15            /* Parity error is detected. */
#define ERR_NOISE        16            /* Noise error is detected. */
#define ERR_IDLE         17            /* Idle error is detectes. */
#define ERR_FAULT        18            /* Fault error is detected. */
#define ERR_BREAK        19            /* Break char is received during communication. */
#define ERR_CRC          20            /* CRC error is detected. */
#define ERR_ARBITR       21            /* A node losts arbitration. This error occurs if two nodes start transmission at the same time. */
#define ERR_PROTECT      22            /* Protection error is detected. */

#endif __PE_Error_H