Standalone GRASS 6 Drivers for GDAL and OGR	===========================================This package contains standalone drivers for GRASS raster and vectorfiles that can be built after GDAL has been built and installed as an "autoload" driver.  This is particularly useful in resolving problems with GRASS dependingon GDAL, but GDAL with GRASS support depending on GRASS.  With this package you can configure and install GDAL normally (--without-grass), thenbuild and install GRASS normally and finally build and install this driver.To build this driver it is necessary for it to find GDAL and GRASS supportfiles.  Typically the configure and build process would look something like:./configure --with-gdal=/usr/local/bin/gdal-config --with-grass=/usr/local/grass-6.0.0makesudo make installSee also:  http://www.gdal.org/  http://grass.itc.it/---FAQs----Question:I am trying to install gdal-grass 1.3.1 on Red hat enterprise linuxadvanced server 3.0. I have previously installed gdal 1.3.1 without-grass, and Grass 6.0.1 with-gdal. I have tried to configure gdal-grasswith:./configure --with-gdal=/usr/local/gdal/bin/gdal-config --with-grass=/usr/local/grass-6.0.1It seems to find gdal alright, but then balks at the Grass location. TheGrass location specified above is indeed the correct location. I havealso tried adding --with-grass=/usr/local/grass-6.0.1/lib, but with nosuccess. My error is:...checking for G_asprintf in -lgrass_gis ... noconfigure: error: --with-grass=/usr/local/grass-6.0.1 requested, butlibraries not found?Answer:Your problem is likely to be solved by editing /etc/ld.so.conf to include the locations of proj, gdal, grass, and geos. Specifically, the full path to both gdal-config and geos-config, and the full paths to the library locations of proj (often /usr/local/lib) and grass (/usr/local/grass-6.0.1/lib). After editing ld.so.conf, run ldconfig, and you should be good to go.I ran into this problem this weekend (and posted for help to this list), so it seems to be a pretty common issue.