;
; VAG-COM label file 3D0-907-553.lbl
;
; VW Phaeton (3D) - up to and including model year 2005 (fully tested with 2004 W12 Phaeton)
; VW Bentley Continental GT - up to and including model year 2005 (not tested with this vehicle)
;
; Component: Level Control System -J197- (#34)
;
; p/n: 3D0 907 553 A
;      3D0 907 553 B Component: LUFTFDR.-CDC- 3C1V0 1101 (Phaeton) - fully tested on this vehicle
;      3D0 907 553 C
;      3W0 907 553   Component: LUFTFDR.-CDC- 3C1V0 7014 (Bentley) - not tested on this vehicle
;      Not suitable for the Touareg. Use the existing file 7L6-907-553.lbl for the Touareg.
;
; includes measured value blocks, coding, and adaptation.  Also user guidance (remarks) embedded in the file.
;
; by Sebastian Stange (Sebastian@ross-tech.com)
; modified by Michael Moore (Moore@ross-tech.com) 'PanEuropean' on the VW Vortex forum.
; tested on a 2004 W12 Phaeton - not all blocks may show on other vehicles.
;
; last modified: 11/05/2004 (Sebastian)
; last modified: 27/March/2005 (Michael)
;
; ready for VAG-COM 402.3 and above
;
;
;---------------------------------------------------
;
; measured value block information
;
;---------------------------------------------------
;
001,0,General Vehicle Values
001,1,Term 15 (Ignition),Voltage,Specified value: 0...20 V
001,2,Term 30 (Battery),Voltage,Specified value: 0...20 V
001,3,Vehicle speed,km/h,Specified value: 0...250 km/h
001,4,Terminal 50,(Starter) status,Specified value: Terminal 50 off/Terminal 50 on
;
002,0,General Vehicle Values (continued)
002,1,Door recognition,status,Door open/Door closed
002,2,Trunk lid,status,Specified value: Lid open/Lid closed
002,3,Right Sensor,Supply Voltage,Specified value: 0...10 V
002,4,Left Sensor,Supply Voltage,Specified value: 0...10 V
;
003,0,General Status of level Control Systel
003,1,Air tank,pressure,,Pressure in the main system accumulator tank, by the compressor.
003,2,Shock absorber,button,This is the button with the picture of the shock absorber on it. Specified value: pressed/not pressed
003,3,Level change,button,This is the button with the picture of the car and the up-down arrow. Specified value: pressed/not pressed
003,4,Compressor,relay,Specified value: Relay off/Relay on
;
004,0,Deviation from assigned (normal) level
004,1,Front Left,,Specified value: -127...+128 mm
004,2,Front Right,,Specified value: -127...+128 mm
004,3,Rear Left,,Specified value: -127...+128 mm
004,4,Rear Right,,Specified value: -127...+128 mm
;
005,0,Absolute vehicle height
005,1,Front Left,,Specified value: 0...255
005,2,Front Right,,Specified value: 0...255
005,3,Rear Left,,Specified value: 0...255
005,4,Right Rear,,Specified value: 0...255
;
006,0,Air Compressor assembly (in spare wheel well) system status
006,1,Compressor,temperature,Specified value: -40...+140 癈
006,2,Air tank,pressure,Specified value: 0...20 bar
006,3,Vent valve,status,Specified value: open/closed
006,4,Accumulator,valve status,Specified value: open/closed
;
007,0,Differential lock valves switch sstatus
007,1,Front Left,,Specified value: off/on
007,2,Front Right,,Specified value: off/on
007,3,Rear Left,,Specified value: off/on
007,4,Rear Right,,Specified value: off/on
;
;Remark- need to check all blocks in 08 on Phaeton, these were lifted from the Touareg file.
008,0,Pitch angle (possibly this may not be used on the Phaeton)
008,1,Pitch angle,increments
008,2,Pitch angle,duty cycle (%)
008,3,System Status
008,4,Workshop,code (presumed)
;
009,0,Average axle height deviation
009,1,System Status
009,2,Longitudinal,Acceleration
;Remark - need to check blocks 09-1 and 09-2 on Phaeton, these were lifted from the Touareg file.
009,3,Front axle,deviation,Specified value: -127...+128 mm
009,4,Rear axle,deviation,Specified value: -127...+128 mm
;
010,0,Vehicle level deviation at each wheel
010,1,Left Front,,Specified value: -127...+128 mm
010,2,Right Front,,Specified value: -127...+128 mm
010,3,Left Rear,,Specified value: -127...+128 mm
010,4,Right Rear,,Specified value: -127...+128 mm
;
011,0,Shock absorber valve current draw
011,1,Left Front,,Specified value: 0...2050 mA
011,2,Right Front,,Specified value: 0...2050 mA
011,3,Left Rear,,Specified value: 0...2050 mA
011,4,Right Rear,,Specified value: 0...2050 mA
;
012,0,Body acceleration signals
012,1,Left Front,,Specified value: 0...5 V
012,2,Right Front,,Specified value: 0 .. 5 V
012,3,Rear Axle,,Specified value: 0 .. 5 V
;
013,0,Wheel acceleration signals
013,1,Left Front,wheel,Specified value: 0...5 V
013,2,Right Front,wheel,Specified value: 0...5 V
013,3,Left Rear,wheel,Specified value: 0...5 V
013,4,Right Rear,wheel,Specified value: 0...5 V
;
14,1,Shock Absorber,(CDC) pushbutton,This shows whether the button with the shock absorber icon on it is depressed or not.,pressed/not pressed
14,2,Current suspension,setting chosen,0/1/2/3,comfort/normal/sport 1/sport 2
14,3,CDC display,in MFI (Y24),This indicates whether there is a display of suspension status at this moment on the instrument cluster.,on/off
;
015,0,Vehicle Operations Information
015,1,Steering wheel,angle,Specified value: +/- 720