//******************************************************************************
//  MSP-FET430P120 Demo - ADC10, Sample A0, 1.5V Ref, Set P1.0 if > 0.2V
//
//  Description: A single sample is made on A0 with reference to internal
//  1.5V Vref. Software sets ADC10SC to start sample and conversion - ADC10SC
//  automatically cleared at EOC. ADC10 internal oscillator times sample (16x)
//  and conversion. In Mainloop MSP430 waits in LPM0 to save power until ADC10
//  conversion complete, ADC10_ISR will force exit from any LPMx in Mainloop on
//  reti. If A0 > 0.2V, P1.0 set, else reset.
//  //* MSP430F1232 or MSP430F1132 Device Required *//
//
//                MSP430F1232
//             -----------------
//         /|\|              XIN|-
//          | |                 |
//          --|RST          XOUT|-
//            |                 |
//        >---|A10          P1.0|-->LED
//
//  M. Buccini
//  Texas Instruments Inc.
//  Feb 2005
//  Built with IAR Embedded Workbench Version: 3.21A
//******************************************************************************

#include  <msp430x12x2.h>

void main(void)
{
  WDTCTL = WDTPW + WDTHOLD;                 // Stop WDT
  ADC10CTL0 = SREF_1 + ADC10SHT_2 + REFON + ADC10ON + ADC10IE;
  _EINT();                                  // Enable interrupts.
  TACCR0 = 30;                              // Delay to allow Ref to settle
  TACCTL0 |= CCIE;                          // Compare-mode interrupt.
  TACTL = TASSEL_2 | MC_1;                  // TACLK = SMCLK, Up mode.
  LPM0;                                     // Wait for delay.
  TACCTL0 &= ~CCIE;                         // Disable timer Interrupt
  _DINT();
  ADC10AE |= 0x01;                          // P2.0 ADC option select
  P1DIR |= 0x01;                            // Set P1.0 to output direction

  for (;;)
  {
    ADC10CTL0 |= ENC + ADC10SC;             // Sampling and conversion start
    _BIS_SR(CPUOFF + GIE);                  // LPM0, ADC10_ISR will force exi
    if (ADC10MEM < 0x88)                    // ADC10MEM = A0 > 0.2V?
    P1OUT &= ~0x01;                         // Clear P1.0 LED off
    else
    P1OUT |= 0x01;                          // Set P1.0 LED on
  }
}

// ADC10 interrupt service routine
#pragma vector=ADC10_VECTOR
__interrupt void ADC10_ISR (void)
{
    _BIC_SR_IRQ(CPUOFF);                    // Clear CPUOFF bit from 0(SR)
}

#pragma vector=TIMERA0_VECTOR
__interrupt void ta0_isr(void)
{
  TACTL = 0;
  LPM0_EXIT;                                // Exit LPM0 on return
}// ta0_isr()