#include "Target\44blib.h"

#include "flashtest\flashrom.h"

/********************************************/
//   ARMSYS實驗二：flash ROM 擦除寫入測試 
//   描述：對SST39VF160進行擦除和寫入操作                    
/********************************************/


void Main(void)
{
	int  i;
	char aa;
	INT16U  temp;
	//rSYSCFG=CACHECFG;	// Using 8KB Cache//

	Uart_Init(0,115200);
	Led_Display(0xf);
	Delay(0);
	
	Uart_Select(0); //Select UART0//
	Beep(0x1);
	Uart_Printf("\n\n*************************************************************************");
	Beep(0x0);
	Uart_Printf("\n*                              立泰電子                                  *");
	Uart_Printf("\n*                      -flash ROM 讀寫測試程序-                          *");
	Uart_Printf("\n*                            Version 1.10                               *");    
	Uart_Printf("\n*                       Email:rao_dali@263.net                          *");
	Uart_Printf("\n*             UART Config--COM:115.2kbps,8Bit,NP,UART0                  *");
	Uart_Printf("\n*-----------------------Test flash? (Y/N)-------------------------------*");
    
	Led_Display(0x0);
    
	aa= Uart_Getch();
	
	if((aa=='Y')||(aa=='y'))
	{
    	SST39VF160_SectorErase(0xff800);
		   Uart_Printf("\nSector erase successfully!");
    	if(SST39VF160_CheckBlank(0xff800,2048))//是否為空
	    {
		   Uart_Printf("\nBlank check OK! Begin to Write the sector...");
		   for(i=0;i<2048;i++)
		   {
		      if(SST39VF160_WordProg(0xff800+i,0xaa55))
		      {
		      	Delay(2);
		      	}
		      else
		      	  Uart_Printf("adr=%d,Write Error",i);
		   }
		   Uart_Printf("\nWrite OK! Begin to Verify... ");   
           for(i=0;i<2048;i++)
           {
              temp = Readflash(0xff800+i);
              if(temp!= 0xaa55)
              {
              	 Uart_Printf("\nadr=%4d,temp = %4x Verify Error!",i,temp);	      
		         //break;
		      }
		   }
		   Uart_Printf("\nVerify OK! Begin to erase the sector...");
		   SST39VF160_SectorErase(0xff800);
		   Uart_Printf("\nSector erase successfully!");
		}
		else
		Uart_Printf("\nThe Sector is not empty! Abort the test!");
	}  
	
	while(1);
}