//============================================================================
// Filename:     arm_boot.h
//
// Description:  This file contains the functions prototypes and definitions
// to load and start the DSP.
//
// Copyright (C) 2000 - 2002 Texas Instruments Incorporated
//
// Revision History:
//
//============================================================================


#ifndef _ARM_BOOT_H_
#define _ARM_BOOT_H_

// Physical Chip Specific Addresses 
#define ARM_API_MEM_START   (0xFFE00000)
#define DSP_API_MEM_START   (0x2000)

// A helper macro to convert a DSP API address into an ARM API address.  
// Note that DSP adresses are in words while ARM addresses are in bytes
#define MAP_DSP_TO_ARM(dsp_address) \
                 (ARM_API_MEM_START + (dsp_address - DSP_API_MEM_START) * 2)


// API transfer buffer address (DSP addresses)
#define API_BUF_START       0x3900
#define API_BUF_END         0x3F80
// API transfer buffer size (in 16-bit words)
#define API_BUF_LENGTH      (API_BUF_END - API_BUF_START) 

// ARM addresses used for hand-shaking flags
#define DSP_READY           MAP_DSP_TO_ARM(0x3800)
#define PROG_BUF_READY      (DSP_READY + 1*2)
#define DATA_BUF_READY      (DSP_READY + 2*2)
#define COPY_DONE           (DSP_READY + 3*2)
#define PMST_VAL            (DSP_READY + 4*2)


// Timeout value to give up on DSP loading code (10 sec)
#define TIME_OUT_COUNT		   (10000000)

#define LOAD_OK         (0)
#define LOAD_TIME_OUT	(1)


typedef struct {
    const unsigned short *pprogram;
    const unsigned short *pdata;
    const unsigned short  pmst;
} dsp_app_struct;

extern int  dsp_load(dsp_app_struct *pDsp_App);
extern void dsp_start(void);

extern void resetinterrupts(void);
extern void pll_init(unsigned long ARM_Freq, unsigned long DSP_Freq);

#endif /* _ARM_BOOT_H_ */