/*****************************************************************************//* *	crt0_ram.S -- startup code for Feith CLEOPATRA board. * *	(C) Copyright 2001, Roman Wagner. * * 	1999/02/24 Modified for the 5307 processor David W. Miller *//*****************************************************************************/#include "linux/autoconf.h"#include "asm/coldfire.h"#include "asm/mcfsim.h"/*****************************************************************************//* *	Feith CLEOPATRA board, chip select and memory setup.*/#define	MEM_BASE	0x00000000	/* Memory base at address 0 */#define	VBR_BASE	MEM_BASE	/* Vector address */#if defined(CONFIG_RAM16MB)#define	MEM_SIZE	0x01000000	/* Memory size 16Mb */#else#define	MEM_SIZE	0x00800000	/* Memory size 8Mb */#endif/*****************************************************************************/.global	_start.global _rambase.global _ramvec.global	_ramstart.global	_ramend/*****************************************************************************/.data/* *	Set up the usable of RAM stuff. Size of RAM is determined then *	an initial stack set up at the end. */_rambase:.long	0_ramvec:.long	0_ramstart:.long	0_ramend:.long	0/*****************************************************************************/.text/* *	This is the codes first entry point. This is where it all *	begins... */_start:	nop					/* Filler */	move.w	#0x2700, %sr			/* No interrupts */	/*	 * Setup VBR here, otherwise buserror remap will not work.	 * if dBug was active before (on my SBC with dBug 1.1 of Dec 16 1996)	 *	 * bkr@cut.de 19990306	 *	 * Note: this is because dBUG points VBR to ROM, making vectors read	 * only, so the bus trap can't be changed. (RS)	 */	move.l	#VBR_BASE, %a7			/* Note VBR can't be read */	movec   %a7, %VBR	move.l	%a7, _ramvec			/* Set up vector addr */	move.l	%a7, _rambase			/* Set up base RAM addr */	/*	 *	Determine size of RAM, then set up initial stack.	 *//* * The current version of the 5307 processor * SWT does not work. Probing invalid addresses * will hang the system. * * For now, set the memory size to 8 meg */	move.l	#MEM_SIZE, %a0	move.l	%a0, %d0			/* Mem end addr is in a0 */	move.l	%d0, %sp			/* Set up initial stack ptr */	move.l	%d0, _ramend			/* Set end ram addr */	/* now fire off the cache, remember to invalidate it first */	movl  #0,%d0	movc  %d0,%CACR	nop	movc  %d0,%CACR				/* cache is off */	movl  #CACR_CINVA,%d0			/* invalidate whole cache */	movc  %d0,%CACR	nop	movc  %d0,%CACR	nop                                    	/* make region ROM cachable (turn off for flash programming?) */	/* 0xff000000 - 0xffffffff */	movl #(0xff<<ACR_BASE_POS)+(0<<ACR_MASK_POS)+ACR_ENABLE+ACR_ANY+ACR_CM_WBACK+ACR_WPROTECT,%d0	movc  %d0,%ACR0	/* make region RAM cachable *	/* 0x00000000 - 0x00ffffffff */	movl #(0x00<<ACR_BASE_POS)+(0<<ACR_MASK_POS)+ACR_ENABLE+ACR_ANY+ACR_CM_WBACK,%d0	movc  %d0,%ACR1	/* make the default cache mode precise */	movl  #CACR_EC+CACR_ESB+CACR_DCM_OFF_PRE,%d0 /* enable cache */	movc  %d0,%CACR#ifdef CONFIG_ROMFS_FS	/*	 *	Move ROM filesystem above bss :-)	 */	lea.l	_sbss, %a0			/* Get start of bss */	lea.l	_ebss, %a1			/* Set up destination  */	move.l	%a0, %a2			/* Copy of bss start */	move.l	8(%a0), %d0			/* Get size of ROMFS */	addq.l	#8, %d0				/* Allow for rounding */	and.l	#0xfffffffc, %d0		/* Whole words */	add.l	%d0, %a0			/* Copy from end */	add.l	%d0, %a1			/* Copy from end */	move.l	%a1, _ramstart			/* Set start of ram */_copy_romfs:	move.l	-(%a0), %d0			/* Copy dword */	move.l	%d0, -(%a1)	cmp.l	%a0, %a2			/* Check if at end */	bne	_copy_romfs#else /* CONFIG_ROMFS_FS */	lea.l	_ebss, %a1	move.l	%a1, _ramstart#endif /* CONFIG_ROMFS_FS */	/*	 *	Zero out the bss region.	 */	lea.l	_sbss, %a0			/* Get start of bss */	lea.l	_ebss, %a1			/* Get end of bss */	clr.l	%d0				/* Set value */_clear_bss:	move.l	%d0, (%a0)+			/* Clear each word */	cmp.l	%a0, %a1			/* Check if at end */	bne	_clear_bss	/*	 * load the current task pointer and stack	 */	lea	init_thread_union, %a0	lea	0x2000(%a0), %sp	/*	 *	Assember start up done, start code proper.	 */	jsr	start_kernel			/* Start Linux kernel */_exit:	jmp	_exit				/* Should never get here *//*****************************************************************************/