/*
 * DEMO of maxqi2c Software I2C Driver
 * (uses evkits for the MAX1169 and MAXQ2000)
 *
 * by: Paul Holden - MAXIM INTEGRATED PRODUCTS
 *
 * 
 * DESC: Test program for the maxqi2c.c/maxqi2c.h I2C
 *       driver for the MAXQ2000. The program reads
 *       16-bit samples from the MAX1169 (running in 
 *       continuous conversion mode) and transmits them
 *       using the UART0 port.
 *
 * NOTE - THE FOLLOWING CODE ASSUMES THE MAXQ2000 HAS
 *        A Fsysclk=20MHz.
 */

#include "iomaxq200x.h"
#include "maxqi2c.h"

void main()
{
   unsigned char data[2];

   // 1. Init UART0
   PD7_bit.bit0 = 1;      // Set TX0 pin as output
   SCON0        = 0x42;
   SMD0         = 0x02;
   PR0          = 0x07DD; // 19200bps

   // 2. Init bit-banged I2C port
   i2cInit();

   // 3. Send initial I2C request
   // [S] [ADDR+R] [A] [clock_stretch] [DATA0] [A] [DATA1] [A (termination)] 
   i2cData     = (unsigned char *)(&data); // cast needed!
   i2cDataAddr = 0x7E;
   i2cDataLen  = 0x0002;
   i2cDataTerm = I2C_TERM_ACK;
   i2cRecv();

   // 4. Init continuous conversion
   // [clock_stretch] [DATA0] [A] [DATA1] [A (termination)]
   i2cDataAddr = 0x00;

   // 5. Receive a 16-bit sample and transfer it to the UART0 port
   //    one byte at a time. Repeat forever...
   while (1)
   {
      i2cRecv();
      
      while(!SCON0_bit.TI);   // Wait for UART0 Buffer to be empty
      SCON0_bit.TI = 0;       // Reset TI flag
      SBUF0        = data[0]; // Send data byte 0
      while(!SCON0_bit.TI);   // Wait for UART0 Buffer to be empty
      SCON0_bit.TI = 0;       // reset TI flag
      SBUF0        = data[1]; // Send data byte 1
   }
}