// $Id: EEPROMWrite.nc,v 1.3 2003/10/07 21:46:14 idgay Exp $/*									tab:4 * "Copyright (c) 2000-2003 The Regents of the University  of California.   * All rights reserved. * * Permission to use, copy, modify, and distribute this software and its * documentation for any purpose, without fee, and without written agreement is * hereby granted, provided that the above copyright notice, the following * two paragraphs and the author appear in all copies of this software. *  * IN NO EVENT SHALL THE UNIVERSITY OF CALIFORNIA BE LIABLE TO ANY PARTY FOR * DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT * OF THE USE OF THIS SOFTWARE AND ITS DOCUMENTATION, EVEN IF THE UNIVERSITY OF * CALIFORNIA HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. *  * THE UNIVERSITY OF CALIFORNIA SPECIFICALLY DISCLAIMS ANY WARRANTIES, * INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY * AND FITNESS FOR A PARTICULAR PURPOSE.  THE SOFTWARE PROVIDED HEREUNDER IS * ON AN "AS IS" BASIS, AND THE UNIVERSITY OF CALIFORNIA HAS NO OBLIGATION TO * PROVIDE MAINTENANCE, SUPPORT, UPDATES, ENHANCEMENTS, OR MODIFICATIONS." * * Copyright (c) 2002-2003 Intel Corporation * All rights reserved. * * This file is distributed under the terms in the attached INTEL-LICENSE      * file. If you do not find these files, copies can be found by writing to * Intel Research Berkeley, 2150 Shattuck Avenue, Suite 1300, Berkeley, CA,  * 94704.  Attention:  Intel License Inquiry. *//* * Authors:		Jason Hill, David Gay, Philip Levis * Date last modified:  6/3/03 *//** * @author Jason Hill * @author David Gay * @author Philip Levis */includes EEPROM;/** * Write interface for the non-volatile EEPROM * <p> * Write lines to the EEPROM. * Each line is 16 bytes. * <p> * Writes must be surrounded by a <code>startWrite</code>,  * <code>endWrite</code> pair. Writes * are only final when <code>endWrite</code> is called.  * If <code>endWrite</code> is not called, * writes written since the last <code>startWrite</code> have  * undefined contents. */interface EEPROMWrite {  /**   * Tells the EEPROM that we are going to start writing a line   *   * @return SUCCESS if the write is accepted   */  command result_t startWrite();  /**   * Writes the line to the EEPROM   *   * @param line address of the line to be written   * @param buffer buffer of the bytes to be written   *   * @return SUCCESS if successful   */  command result_t write(uint16_t line, uint8_t *buffer);  /**   * Tells the EEPROM that we're done writing   *   * @return SUCCESS if the end command is accepted   */  command result_t endWrite();  /**   * Notification that the write has been completed   *   * @param buffer buffer written to the EEPROM   *   * @return SUCCESS always   */  event result_t writeDone(uint8_t *buffer);    /**   * Notification that the EEPROM has completed writing and ended   * write mode   *   * @param success SUCCESS if the end command was successful   *   * @return SUCCESS always   */  event result_t endWriteDone(result_t success);}