// $Id: SimpleCmd.nc,v 1.3 2003/10/07 21:44:59 idgay Exp $/*									tab:4 * "Copyright (c) 2000-2003 The Regents of the University  of California.   * All rights reserved. * * Permission to use, copy, modify, and distribute this software and its * documentation for any purpose, without fee, and without written agreement is * hereby granted, provided that the above copyright notice, the following * two paragraphs and the author appear in all copies of this software. *  * IN NO EVENT SHALL THE UNIVERSITY OF CALIFORNIA BE LIABLE TO ANY PARTY FOR * DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT * OF THE USE OF THIS SOFTWARE AND ITS DOCUMENTATION, EVEN IF THE UNIVERSITY OF * CALIFORNIA HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. *  * THE UNIVERSITY OF CALIFORNIA SPECIFICALLY DISCLAIMS ANY WARRANTIES, * INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY * AND FITNESS FOR A PARTICULAR PURPOSE.  THE SOFTWARE PROVIDED HEREUNDER IS * ON AN "AS IS" BASIS, AND THE UNIVERSITY OF CALIFORNIA HAS NO OBLIGATION TO * PROVIDE MAINTENANCE, SUPPORT, UPDATES, ENHANCEMENTS, OR MODIFICATIONS." * * Copyright (c) 2002-2003 Intel Corporation * All rights reserved. * * This file is distributed under the terms in the attached INTEL-LICENSE      * file. If you do not find these files, copies can be found by writing to * Intel Research Berkeley, 2150 Shattuck Avenue, Suite 1300, Berkeley, CA,  * 94704.  Attention:  Intel License Inquiry. *//**  * Configuration for SimpleCmd module. * * Author/Contact: tinyos-help@millennium.berkeley.edu *  * Description: * * SimpleCmd module demonstrates a simple command interpreter for TinyOS tutorial  * (Lesson 8 in particular).  It receives a command message from its RF interface, * which triggers a command interpreter task to execute the command. * When the command is finished executing, the component signals the upper  * layers with the received message and the status indicating whether the message * should be further processed.  * * As a simple version,  it can only interpret the follwoing commands: * Led_on (1), Led_off(2), radio_quieter(3), radio_louder(4),  * start_sensing(5), and read_log(6). Start sensing commands will trigger  * the Sensing.start interface while read log will read the EEPROM with  * a specific log line and broadcast the line over the radio when read is done. */includes SimpleCmdMsg;configuration SimpleCmd {  provides interface ProcessCmd;}implementation {  components Main, SimpleCmdM, SenseLightToLog, Logger,    GenericComm as Comm, PotC, LedsC;  Main.StdControl -> SimpleCmdM;  SimpleCmdM.Leds -> LedsC;  ProcessCmd = SimpleCmdM.ProcessCmd;  SimpleCmdM.CommControl -> Comm;  SimpleCmdM.ReceiveCmdMsg -> Comm.ReceiveMsg[AM_SIMPLECMDMSG];  SimpleCmdM.SendLogMsg -> Comm.SendMsg[AM_LOGMSG];  SimpleCmdM.LoggerRead -> Logger;  SimpleCmdM.Pot -> PotC;  SimpleCmdM.Sensing -> SenseLightToLog.Sensing;}