.TH "ATHDEBUG" "8" "February 2006" "" "".SH "NAME"\fBathdebug\fP \- control the debug output from the madwifi device subsystem.SH "SYNOPSIS".B athdebug[-i device] +/\- bitmap.SH "DESCRIPTION"Set and clear debug bitmaps for the madwifi ath device subsystem. Each argumentis a bitmap or its alias. If a bitmap alias is used then it must be prefixed by either "-" to clear or "+" to set the corresponding bitmap..PPAll debugging output can be enabled with the 0xffffffff bitmap, while 0x0disables all debug output..PP.SH "OPTIONS".TP.B \-?Display usage and list all debug flags..TP.B \-i deviceThe madwifi device to apply the settings to. If no interface is specified, \fBathdebug\fP defaults to wifi0..TP.B +/\- bitmapSet (+) or clear (-) a debug flag..PP.SH "BITMAP ALIASES".BI xmit\- transmit of packets, just before they go out to the HW.br.BI xmit_desc\- transmit descriptors.br.BI recv\- received packets, directly from the HW.br.BI recv_desc\- recv descriptors.br.BI rate\- rate control modules.br.BI reset\- reset processing and inititalization.br.BI mode\- mode initialization and changes.br.BI beacon\- beacon handling.br.BI watchdog\- watchdog timeout.br.BI intr\- interrupt processing.br.BI xmit_proc\- processing of transmit descriptors.br.BI recv_proc\- processing of receive descriptors.br.BI beacon_proc\- beacon processing.br.BI calibrate\- periodic re-calibration.br.BI keycache\- key cache management.br.BI state\- 802.11 state transitions.br.BI node\- node management.BI ff\- fast frame handling.br.BI fatalfatal errors.br.PP.SH "EXAMPLES".TP.B athdebug \-i wifi1 0xffffffffEnable all debug bitmaps on wifi1..TP.B athdebug +rateEnable rate debug bitmap on wifi0..TP.B athdebug \-rateClear rate bitmap on wifi0..PP.SH "SEE ALSO"\fB80211debug\fP(8), \fBhttp://madwifi.org/wiki/DevDocs/AthDebug\fP.SH "AUTHOR"This manual page was written by Kel Modderman <kelrin@tpg.com.au> and was basedupon previous text written by Eric S. Raymond.