## Copyright (c) 2002-2006 Sam Leffler, Errno Consulting# All rights reserved.## Redistribution and use in source and binary forms, with or without# modification, are permitted provided that the following conditions# are met:# 1. Redistributions of source code must retain the above copyright#    notice, this list of conditions and the following disclaimer,#    without modification.# 2. Redistributions in binary form must reproduce at minimum a disclaimer#    similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any#    redistribution must be conditioned upon including a substantially#    similar Disclaimer requirement for further binary redistribution.# 3. Neither the names of the above-listed copyright holders nor the names#    of any contributors may be used to endorse or promote products derived#    from this software without specific prior written permission.## Alternatively, this software may be distributed under the terms of the# GNU General Public License ("GPL") version 2 as published by the Free# Software Foundation.## NO WARRANTY# THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS# ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT# LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY# AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL# THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY,# OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF# SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS# INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER# IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)# ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF# THE POSSIBILITY OF SUCH DAMAGES.## $Id: //depot/sw/branches/sam_hal/public/xscale-le-elf.inc#2 $### Compilation configuration for building little-endian XScale/arm-elf.## NB: built with AH_REGOPS_FUNC to so that register accesses#     can be done using the Linux readl/writel functions on#     systems that need it.## Reported to work on:#	Compulab's ARMBASE using ARMCORE GX#		(http://www.compulab.co.il/armbase.htm)### Built with GNU cross-devel tools:## PREFIX=/pub/gnu# BINUTILS=binutils-2.14# GCC=gcc-3.3.2# target=arm-elf## ${BINUTILS}/configure --target=$target --prefix=${PREFIX}# ${GCC}/configure --target=$target   --prefix=${PREFIX} \#	--enable-languages=c   --with-gnu-as --with-gnu-ld \#	--with-newlib   --with-gxx-include-dir=${PREFIX}/$target/include#ifndef TOOLPREFIXTOOLPREFIX=	/pub/gnu/bin/arm-elf-endif#CC=	${TOOLPREFIX}gccLD=	${TOOLPREFIX}ldSTRIP=	${TOOLPREFIX}stripOBJCOPY=${TOOLPREFIX}objcopyNM=	${TOOLPREFIX}nm## Force register read/write operations to go through a function.#AH_REGOPS_FUNC=1LDOPTS=	-ELCOPTS+=	-DAH_BYTE_ORDER=AH_LITTLE_ENDIANCOPTS+= -march=armv4 -mlittle-endian -fno-strict-aliasing -fno-common \	-mapcs-32 -mtune=xscale  -mshort-load-bytes -msoft-float -mfp=2