/*------------------------------------------------------------------------------
upsd3200_hardware.h

Dependencies: None

Description:
This header file contains the hardware specific defines for the uPSD3200
processor being used.

*******************************************************************************
Important Note: These values must be modified for the specific target hardware.
Some of the parameters may be used in the uPSD initialization code (see
startu32.a51) and may be used by drivers to set up timers, prescalers, etc. 
*******************************************************************************


Copyright (c) 2004 STMicroelectronics Inc.

This example demo code is provided as is and has no warranty,
implied or otherwise.  You are free to use/modify any of the provided
code at your own risk in your applications with the expressed limitation
of liability (see below) so long as your product using the code contains
at least one uPSD product (device).

LIMITATION OF LIABILITY:   NEITHER STMicroelectronics NOR ITS VENDORS OR 
AGENTS SHALL BE LIABLE FOR ANY LOSS OF PROFITS, LOSS OF USE, LOSS OF DATA,
INTERRUPTION OF BUSINESS, NOR FOR INDIRECT, SPECIAL, INCIDENTAL OR
CONSEQUENTIAL DAMAGES OF ANY KIND WHETHER UNDER THIS AGREEMENT OR
OTHERWISE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
------------------------------------------------------------------------------*/

//Hardware MCU specific settings
#define FREQ_OSC  	36000	    // uPSD MCU Oscillator Freq. in KHz (not MHz)
#define uPSD_5V         1           // uPSD_5V = 1  --> 5V device
                                    // uPSD_5V = 0  --> 3V device    


// Memory map settings:
// These settings must match up with the settings in the associated PSDsoft
// project for proper execution of the code as well as the Physical Hardware.
// Note: Also the settings in the Complier IDE tool must match as well.

#define PSD_REG_ADDR    0x0200          // uPSD PSD Register I/O base addr
                                        // (PSDsoft CSIOP value)

#define XMEM_BASE_ADDR  0x2000          // XDATA base address (PSDsoft RS0 value)
#define XMEM_LENGTH     0x2000          // XDATA length 8KB

#define uPSD_MAIN_SECTOR_SIZE   0x8000	// Main Sector size = 32KB
#define uPSD_BOOT_SECTOR_SIZE   0x2000	// Boot Sector size = 8KB
#define uPSD_MAIN_SECTORS       0x08	// Number of Main sectors = 8
#define uPSD_BOOT_SECTORS       0x04	// Number of Boot sectors = 4


// Optional hardware definitions used for DK3200 boards
// Customer would need to add their own hardware definitions here

#define LCD_BASE_ADDR   0x0300          // LCD base address