LABCENTER PROTEUS TOOL INFORMATION FILE
=======================================

In case of difficulty, please e-mail support@labcenter.co.uk

Tool set up for Proteus layout 'F:\安裝包\電子\proteus\Proteus AVR應用實例\key_lcd\key_lcd.LYT'.
CADCAM generated at 21:21:06 on 2007年10月22日.

File List
---------
Top Copper              : key_lcd - CADCAM Top Copper.TXT
Bottom Copper           : key_lcd - CADCAM Bottom Copper.TXT
Top Silk Screen         : key_lcd - CADCAM Top Silk Screen.TXT
Bottom Solder Resist    : key_lcd - CADCAM Bottom Solder Resist.TXT
Top SMT Paste Mask      : key_lcd - CADCAM Top SMT Paste Mask.TXT
Drill                   : key_lcd - CADCAM Drill.TXT

Photoplotter Setup
------------------
Format: RS274X, ASCII, 2.4, imperial, absolute, eob=*, LZO
Notes:  D=Diameter, S=Side, W=Width, H=Height

D10	SQUARE	S=80th                                      FLASH
D11	CIRCLE	D=8th                                       DRAW
D12	SMT	W=100th               H=100th               FLASH

NC Drill Setup
--------------
Format: ASCII, 2.4, imperial, absolute, eob=<CR><LF>, no zero suppression.
Notes:  Tool sizes are diameters. Layer sets are in brackets - 0=TOP, 15=BOTTOM, 1-14=INNER.

T01	40th (0-15)


[END OF FILE]