# Example iscsi target configuration## Everything until the first target definition belongs# to the global configuration.# Right now this is only the user configuration used# during discovery sessions. "IncomingUser" specifies credentials the# initiator has to provide - several of these are supported. If mutual# CHAP shall be employed, "OutgoingUser" specifies the user/pass# combination the target will provide - only one is supported.# Leave them alone (keep them commented out) if you don't want to use# authentication for discovery sessions.#iSNSServer 192.168.1.16#iSNSAccessControl No#IncomingUser joe secret#OutgoingUser jack 12charsecret# Targets definitions start with "Target" and the target name.# The target name must be a globally unique name, the iSCSI# standard defines the "iSCSI Qualified Name" as follows:## iqn.yyyy-mm.<reversed domain name>[:identifier]## "yyyy-mm" is the date at which the domain is valid and the identifier# is freely selectable. For further details please check the iSCSI spec.Target iqn.2001-04.com.example:storage.disk2.sys1.xyz	# Users, who can access this target. The same rules as for discovery	# users apply here.	# Leave them alone if you don't want to use authentication.	#IncomingUser joe secret	#OutgoingUser jim 12charpasswd	# Logical Unit definition	# You must define one logical unit at least.	# Block devices, regular files, LVM, and RAID can be offered	# to the initiators as a block device.	#Lun 0 Path=/dev/sdc,Type=fileio	# Alias name for this target	# Alias Test	# various iSCSI parameters	# (not all are used right now, see also iSCSI spec for details)	#MaxConnections		1	#InitialR2T		Yes	#ImmediateData		No	#MaxRecvDataSegmentLength 8192	#MaxXmitDataSegmentLength 8192	#MaxBurstLength		262144	#FirstBurstLength	65536	#DefaultTime2Wait	2	#DefaultTime2Retain	20	#MaxOutstandingR2T	8	#DataPDUInOrder		Yes	#DataSequenceInOrder	Yes	#ErrorRecoveryLevel	0	#HeaderDigest		CRC32C,None	#DataDigest		CRC32C,None	# various target parameters	#Wthreads		8