//中斷方式
//==============================================================================
//本觸摸屏程序只適用于金鵬公司D型液晶模塊，顯示點數按OCMJ8X15D液晶模塊顯示，即240X128點陣顯示。
//本程序利用液晶模塊的觸摸屏中斷信號輸出到lcd_int腳由MCU的INT0接收。
//==============================================================================
#include "init.c"

uchar code tab1[] = "金鵬電子有限公司Ｄ系列液晶模塊"
		    "    內嵌觸摸屏功能演示程序    "
		    "          No-Touch!!          "
                    "           X=                 "
                    "           Y=                 ";
uchar code tab2[] = "No-Touch!!";
uchar code tab3[] = "Touch-Now!";

//==============================================================================
void Get_Touch_XY(void)
{
	uchar temp;
	uint X1, X2, Y1 ,Y2;
	
	lcd_regwrite(0xc0, 0xc0);//touch on
	
	Y1 = Touch_Y();
	X1 = Touch_X();
		
	Delay1ms(2);
			
	if(Test_Touch())
	{	
		Y2 = Touch_Y();
		X2 = Touch_X();
		
		if((X1==X2) && (Y1==Y2))
		{	
			/*已獲得確實的觸摸坐標X1、Y1*/
			
			gotoxy(10, 32);
			LCD_Bold();
			for(temp=0 ; temp<11 ; temp++)
			{	
				lcd_datawrite(tab3[temp]);
			}
			gotoxy(14, 48);
			Print_Hex(X1);
			gotoxy(14, 64);
			Print_Hex(Y1);
			LCD_NoBold();
			
			//delay1 (100);
			Delay1ms(1);
		}
	}
	lcd_regwrite(0xc0, 0x00);//touch off
	
	gotoxy(10, 32);
	for(temp=0 ; temp<11 ; temp++)
	{	
		lcd_datawrite(tab2[temp]);
	}
}

//==============================================================================
void lcd_touch_init(void)
{	
	uchar temp;
	
	temp=lcd_regread(0xa0)|0x04;//enable lcd touch int
	lcd_regwrite(0xa0, temp);
		
}
//==============================================================================
void Ext_int0(void) interrupt 0
{
	EA=0;
	
	if(0x40==(lcd_regread(0xa0)&0x40))      //test bit6 touch int is "1"?
	{
		Get_Touch_XY();
	}
	EA=1;
}
/******************************************************************************/
/*Main program 		  													  */
/******************************************************************************/
void main(void)
{
	uchar temp;
		
	lcd_reset();
  	lcd_initial();
	lcd_clear();
	
	lcd_touch_init();
	
	lcd_regwrite(0x10,0x6b);
   	lcd_regwrite(0x00,0xcd);
   	
	gotoxy(0, 0);
	for(temp=0 ; temp<149 ; temp++)
	{	
		lcd_datawrite(tab1[temp]);
	}
	
	IT0=1;
	EA=1;
	EX0=1;
	
	while(1);

}