/*===========================================================================*/
/*                    Register Setting for TW8804C    02/17/05               */
/*===========================================================================*/
//	Input	: NTSC
//	Panel	: WVGA SHARP T-CON LESS PANEL
//-----------------------------------------------------------------------------
//	Below listed registers should not be set.
//	0x02, 0x06, 
//
//

TW88I2CAddress, 120,

0xc5, 0xc1, // ADC PLL=27Mhz
0xc6, 0x25, // 
//------------ Decoder (23) ---------------------------------------------------

0x1c, 0x07,				// Standard, shadow 		** N/P
0x04, 0x00,				// Luminance Gamma
0x07, 0x12,				// Cropping H				** N/P, panel
0x08, 0x15,				// V delay L				** N/P, panel
0x09, 0xf0,				// V active L				** N/P, panel?
0x0a, 0x28,				// H delay L				** N/P, panel
0x0b, 0xd0,				// H active L				** N/P, panel?
0x0c, 0xcd,				// Control Reg 1
0x10, 0x00,				// Brightness
0x11, 0x5a,				// Contrast
0x12, 0x61,				// Sharpness Ctrl 1
0x13, 0x80,				// Chroma(U) gain
0x14, 0x80,				// chroma(V) gain
0x15, 0x00,				// Hue
0x16, 0xc3,				// Sharpness Ctrl 2
0x17, 0x30,				// V peaking Ctrl 1			
0x18, 0x44,				// Coring Ctrl				
0x20, 0x50,
0x21, 0x44,				// AGC gain
0x23, 0xd8,				// White Peak Threshold
0x27, 0x2A, // Default Changed from 0x32
0x35, 0x02,
0x37, 0x28,				// QCLAMP

//---------- Input/Output (4 )-----------------------------------------------------

0x40, 0x00,				// Input
0x41, 0x20,				// Output
0x43, 0x04,				// Input routing
0x44, 0x08,				// Input control

//------------ Zoom ( 7 )-----------------------------------------------------------

0x63, 0x00,				// H/V scale up/dn H		** N/P panel
0x60, 0xdb,				// H-scale up L				** N/P panel
0x61, 0x80,				// H-scale dn L				** N/P panel
0x62, 0x79,				// V-scale up L				** N/P panel
0x64, 0xff,				// H-scale up offset, remove error
0x65, 0x80,				// V-scale up offset
0x66, 0x00,				// H non-display area

//--------- Image Adjust ( 18 )------------------------------------------------------

0x70, 0x60,				// YCbCr/ Hue
0x71, 0x80,				// Y  contrast
0x72, 0x80,				// Cb contrast
0x73, 0x80,				// Cr contrast
0x74, 0x80,				// Y  brightness
0x75, 0x80,				// Cb brightness
0x76, 0x80,				// Cr brightness

0x70, 0x20,				// RGB/ Hue
0x71, 0x80,				// R contrast
0x72, 0x80,				// G contrast
0x73, 0x80,				// B contrast
0x74, 0x80,				// R brightness
0x75, 0x80,				// G brightness
0x76, 0x80,				// B brightness

0x77, 0x30,				// Sharpness=0
//0x78, 0x85,				// Sharpness freq. Filter
0x79, 0x00,				// Edge Enhancement=enable
0x7B, 0x00,				// should be 0x00

//---------- BW/Blue Stretch ( 0 )--------------------------------------------------

//0x84, 0x67,				// BW Stretch Black Tilt
//0x85, 0x94,				// BW Stretch White Tilt
//0x86, 0x20,				// BW Stretch Black Gain, for Disable=00 
//0x87, 0xe0,				// BW Stretch White Gain, for Disable=FF

//0x8a, 0x08,				// Blue Stretch, for Disable=00

//--------- Display control ( 15 )---------------------------------------------------

#ifdef TW8804D	
0xb6, 0x34,				// PHR-H, PHP-H				** N/P panel
#else
0xb6, 0xb4,
#endif
0xb0, 0x40,				// Output Signal Config.
0xb1, 0xc0,				// clock delay, en coast	** panel
0xb2, 0x58,				// PHP-L					** N/P panel
0xb3, 0x03,				// H sync					**
0xb4, 0x1e,				// H back porch				**     panel
0xb5, 0x48,				// PHR-L					**     panel

0xbb, 0x11,				//							**     panel
0xb7, 0xe0,				//							**     panel
0xb8, 0x06,				//							**     panel
0xb9, 0x35,				//							** N/P panel
0xba, 0xF6,				//							**     panel

0xbd, 0x04,
0xbc, 0x21,				// Dithering
0xbe, 0x02,				// Auto Calc.

//--------- Misc. Input ( 3 )-------------------------------------------------------

0xc0, 0x00,				// Initial Counter			** N/P panel
0xc1, 0x00,				//							** N/P panel
0xc2, 0x00,				//							** N/P panel

//--------- PLL ( 5 )---------------------------------------------------------------

0xfa, 0x82,				// 34.000MHz				** N/P panel
0xfb, 0x00,				//							** N/P panel
0xfd, 0x20,				//							** N/P panel
0xfc, 0x28,				//							** N/P panel
0xfe, 0x1d,				//							** N/P panel

//0xff, 0x10,				// disable I2C auto increase mode

//--------- TCON ASIC Register (24) ---------------------------------------
//0xb1, 0xC0,

0xc5, 0x8A,
0xc6, 0x07,

0xc5, 0x8B,
0xc6, 0x04,

0xc5, 0x80,
0xc6, 0x26,

0xc5, 0x81,
0xc6, 0x00,

0xc5, 0x84,
0xc6, 0x6f,

0xc5, 0x82,
//0xc6, 0x07,
0xc6, 0x0,

0xc5, 0xa5,
//0xc6, 0x2A,
0xc6, 0x33,

0xc5, 0xa7,
//0xc6, 0x2c,
0xc6, 0x35,

//Verical Active Period
0xc5, 0x8d,
0xc6, 0x3b,

0xc5, 0x8e,
0xc6, 0x02,

0xc5, 0x8f,
0xc6, 0x1b,

0xc5, 0x83,
0xc6, 0x0B,

//--------- Latch Pulse (21) ------------------------------------------------
0xc5, 0x92,
0xc6, 0x03,

0xc5, 0x93,
0xc6, 0xe0,

0xc5, 0x94,
0xc6, 0x00,

0xc5, 0x95,
0xc6, 0x10,

0xc5, 0x9b,
//0xc6, 0xb7,
0xc6, 0x1e,

0xc5, 0x9d,
//0xc6, 0xb8,
0xc6, 0x20,

0xc5, 0xA0,
0xc6, 0x00,

0xc5, 0xA1,
0xc6, 0x0E,

0xc5, 0xA2,
//0xc6, 0x03,
0xc6, 0x63,

0xc5, 0xA3,
0xc6, 0x8D,

0xff, 0x10,				// disable I2C auto increase mode

0xff, 0xff