?? wv_p_samsung.txt
字號:
/*===========================================================================*/
/* Register Setting for TW8804C 04/29/05 */
/*===========================================================================*/
// Input : PAL
// Panel : WVGA SAMSUNG LTC700WV-F01
//-----------------------------------------------------------------------------
// Below listed registers should not be set.
// 0x02, 0x06,
//
//
TW88I2CAddress, 80,
0xc5, 0xc1, // ADC PLL=27Mhz
0xc6, 0x25, //
//------------ Decoder (23) ---------------------------------------------------
0x1c, 0x08, // Standard, shadow ** N/P
0x04, 0x00, // Luminance Gamma
0x07, 0x22, // Cropping H ** N/P, panel
0x08, 0x17, // V delay L ** N/P, panel
0x09, 0x20, // V active L ** N/P, panel?
0x0a, 0x28, // H delay L ** N/P, panel
0x0b, 0xd0, // H active L ** N/P, panel?
0x0c, 0xcd, // Control Reg 1
0x12, 0x52, // Sharpness Ctrl 1
0x13, 0x80, // Chroma(U) gain
0x14, 0x80, // chroma(V) gain
0x15, 0x00, // Hue
0x16, 0xc3, // Sharpness Ctrl 2
0x17, 0x31, // V peaking Ctrl 1
0x18, 0x44, // Coring Ctrl
0x20, 0x50,
0x21, 0x44, // AGC gain
0x23, 0xd8, // White Peak Threshold
0x27, 0x2A, // Default Changed from 0x32
0x33, 0x05,
0x35, 0x02,
0x37, 0x28, // QCLAMP
//---------- Input/Output (4) -------------------------------------------------
0x40, 0x00, // Input
0x41, 0x20, // Output
0x43, 0x04, // Input routing
0x44, 0x08, // Input control
//------------ Zoom (7) -------------------------------------------------------
0x63, 0x00, // H/V scale up/dn H ** N/P panel
0x60, 0xd8, // H-scale up L ** N/P panel
0x61, 0x80, // H-scale dn L ** N/P panel
0x62, 0x96, // V-scale up L ** N/P panel
0x64, 0xff, // H-scale up offset, remove error
0x65, 0x80, // V-scale up offset
0x66, 0x00, // H non-display area
//--------- Image Adjust (18) ----------------------------------------------
0x70, 0x60, // YCbCr/ Hue
0x71, 0x80, // Y contrast
0x72, 0x80, // Cb contrast
0x73, 0x80, // Cr contrast
0x74, 0x80, // Y brightness
0x75, 0x80, // Cb brightness
0x76, 0x80, // Cr brightness
0x70, 0x20, // RGB/ Hue
0x71, 0x80, // R contrast
0x72, 0x80, // G contrast
0x73, 0x80, // B contrast
0x74, 0x80, // R brightness
0x75, 0x80, // G brightness
0x76, 0x80, // B brightness
0x77, 0x30, // Sharpness=0
//0x78, 0x38, // Sharpness freq. Filter
0x79, 0x00, // Edge Enhancement=enable
0x7B, 0x00, // should be 0x00
//---------- BW/Blue Stretch (5) ----------------------------------------------
0x84, 0x67, // BW Stretch Black Tilt
0x85, 0x94, // BW Stretch White Tilt
0x86, 0x10, // BW Stretch Black Gain, for Disable=00
0x87, 0xF0, // BW Stretch White Gain, for Disable=FF
0x8a, 0x08, // Blue Stretch, for Disable=00
//--------- Display control ---------------------------------------------------
0xbd, 0x04,
0xb0, 0x40, // Output Signal Config.
0xb1, 0x00, // clock delay, en coast ** panel
0xbb, 0x12, // ** panel
0xb7, 0x00, // ** panel
0xb8, 0x1D, // ** panel
0xb9, 0x15, // ** N/P panel
0xba, 0xe8, // ** panel
#ifdef TW8804D
0xb6, 0x33, // PHR-H, PHP-H ** N/P panel
#else
0xb6, 0xb3,
#endif
0xb2, 0xE1, // PHP-L ** N/P panel
0xb3, 0x10, // H sync **
0xb4, 0xaa, // H back porch ** panel
0xb5, 0x20, // PHR-L ** panel
0xbc, 0x21, // Dithering
0xbe, 0x43, // Auto Calc.
//--------- Misc. Input -------------------------------------------------------
0xc0, 0x00, // Initial Counter ** N/P panel
0xc1, 0x00, // ** N/P panel
0xc2, 0x00, // ** N/P panel
//--------- PLL ---------------------------------------------------------------
0xfa, 0xA2, // 65.000MHz ** N/P panel
0xfb, 0x01, // ** N/P panel
0xfd, 0x20, // ** N/P panel
0xfc, 0x66, // ** N/P panel
0xfe, 0x34, // ** N/P panel
//0xff, 0x10, // disable I2C auto increase mode
0xff, 0xff
?? 快捷鍵說明
復制代碼
Ctrl + C
搜索代碼
Ctrl + F
全屏模式
F11
切換主題
Ctrl + Shift + D
顯示快捷鍵
?
增大字號
Ctrl + =
減小字號
Ctrl + -