?? wv_n3(wvga auo tcon less 10inch).txt
字號:
/*===========================================================================*/
/* Register Setting for TW8804C 08/03/05 */
/*===========================================================================*/
// Input : NTSC
// Panel : WVGA AUO T-CON LESS PANEL Ver5.0
// Fix PC input position
//-----------------------------------------------------------------------------
// Below listed registers should not be set.
// 0x02, 0x06,
//
//
TW88I2CAddress, 127-5,
0xc5, 0xc1, // ADC PLL=27Mhz
0xc6, 0x25, //
//------------ Decoder (22-5) ---------------------------------------------------
0x1c, 0x08, // Standard, shadow ** N/P
0x04, 0x00, // Luminance Gamma
0x07, 0x02, // Cropping H ** N/P, panel
0x08, 0x16, // V delay L ** N/P, panel
0x09, 0xf0, // V active L ** N/P, panel?
0x0a, 0x23, // H delay L ** N/P, panel
0x0b, 0xd0, // H active L ** N/P, panel?
0x0c, 0xcc, // Control Reg 1
//0x10, 0x00, // Brightness
//0x11, 0x60, // Contrast
//0x12, 0x52, // Sharpness Ctrl 1
//0x13, 0x80, // Chroma(U) gain
//0x14, 0x80, // chroma(V) gain
//0x15, 0x00, // Hue
0x16, 0xc3, // Sharpness Ctrl 2
0x17, 0x81, // V peaking Ctrl 1
0x18, 0x44, // Coring Ctrl
0x20, 0x50,
0x21, 0x44, // AGC gain
0x23, 0xd8, // White Peak Threshold
0x27, 0x2A, // Default Changed from 0x32
0x35, 0x02,
//---------- Input/Output (4) -------------------------------------------------
0x40, 0x00, // Input
0x41, 0x20, // Output
0x43, 0x04, // Input routing
0x44, 0x08, // Input control
//------------ Zoom (7) -------------------------------------------------------
0x63, 0x00, // H/V scale up/dn H ** N/P panel
0x60, 0xdb, // H-scale up L ** N/P panel
0x61, 0x80, // H-scale dn L ** N/P panel
0x62, 0x7c, // V-scale up L ** N/P panel
0x64, 0xff, // H-scale up offset, remove error
0x65, 0x80, // V-scale up offset
0x66, 0x00, // H non-display area
//--------- Image Adjust (18) ------------------------------------------------
0x70, 0x60, // YCbCr/ Hue
0x71, 0x80, // Y contrast
0x72, 0x80, // Cb contrast
0x73, 0x80, // Cr contrast
0x74, 0x80, // Y brightness
0x75, 0x80, // Cb brightness
0x76, 0x80, // Cr brightness
0x70, 0x20, // RGB/ Hue
0x71, 0x80, // R contrast
0x72, 0x80, // G contrast
0x73, 0x80, // B contrast
0x74, 0x80, // R brightness
0x75, 0x80, // G brightness
0x76, 0x80, // B brightness
0x77, 0x30, // Sharpness=0
//0x78, 0x38, // Sharpness freq. Filter
0x79, 0x00, // Edge Enhancement=enable
0x7B, 0x08, // Panel Sharpness
//---------- BW/Blue Stretch --------------------------------------------------
//0x84, 0x67, // BW Stretch Black Tilt
//0x85, 0x94, // BW Stretch White Tilt
//0x86, 0x10, // BW Stretch Black Gain, for Disable=00
//0x87, 0xF0, // BW Stretch White Gain, for Disable=FF
//0x8a, 0x08, // Blue Stretch, for Disable=00
//--------- Display control (15) ----------------------------------------------
0xbd, 0x04,
0xb0, 0x40, // Output Signal Config.
0xb1, 0x80, // clock delay, en coast ** panel
0xbb, 0x12, // ** panel
0xb7, 0x00, // ** panel
0xb8, 0x01, // ** panel
0xb9, 0x33, // ** N/P panel
0xba, 0xe0, // ** panel
0xb6, 0x34, // PHR-H, PHP-H ** N/P panel
0xb2, 0xae, // PHP-L ** N/P panel
0xb3, 0x03, // H sync **
0xb4, 0x13, // H back porch ** panel
0xb5, 0x20, // PHR-L ** panel
0xbc, 0x21, // Dithering
0xbe, 0x03, // Auto Calc.
//--------- Misc. Input (3) --------------------------------------------------
0xc0, 0x00, // Initial Counter ** N/P panel
0xc1, 0x00, // ** N/P panel
0xc2, 0x00, // ** N/P panel
//--------- Color Enhancement (6) ----------------------------------------------
0xda, 0x9f,
0xdb, 0x39,
0xdc, 0xf0,
0xdd, 0xf6,
0xde, 0xf0,
0xdf, 0xf0,
//--------- PLL (6) -----------------------------------------------------------
0xf9, 0x01,
0xfa, 0x82, // 36.000MHz
0xfb, 0x42, // ** N/P panel
0xfd, 0x10, // ** N/P panel
0xfc, 0x48, // ** N/P panel
0xfe, 0x00, // ** N/P panel
//0xff, 0x10, // disable I2C auto increase mode
//--------- TCON ASIC Register (16) ---------------------------------------
0xc5, 0x80,
0xc6, 0x00,
0xc5, 0x81,
0xc6, 0x00,
0xc5, 0x82,
0xc6, 0x02,
0xc5, 0x83,
0xc6, 0x0f,
0xc5, 0x84,
0xc6, 0x37,
0xc5, 0x8d,
0xc6, 0x06,
0xc5, 0x8e,
0xc6, 0x02,
0xc5, 0x8f,
0xc6, 0x61,
//--------- Latch Pulse (16) -----------------------------------------------
0xc5, 0x90,
0xc6, 0x03,
0xc5, 0x91,
0xc6, 0x34,
0xc5, 0x92,
0xc6, 0x03,
0xc5, 0x93,
0xc6, 0x33,
0xc5, 0x94,
0xc6, 0x03,
0xc5, 0x95,
0xc6, 0x35,
0xc5, 0x9b,
0xc6, 0x13,
0xc5, 0x9d,
0xc6, 0x14,
//--------- Row Clock (08) -----------------------------------------------
0xc5, 0xa0,
0xc6, 0x01,
0xc5, 0xa1,
0xc6, 0x75,
0xc5, 0xa2,
0xc6, 0x01,
0xc5, 0xa3,
0xc6, 0xf4,
//--------- Row Starting Puls (05) -----------------------------------------------
0xc5, 0xa5,
0xc6, 0x31,
0xc5, 0xa7,
0xc6, 0x32,
0xff, 0x10, // disable I2C auto increase mode
0xff, 0xff
?? 快捷鍵說明
復制代碼
Ctrl + C
搜索代碼
Ctrl + F
全屏模式
F11
切換主題
Ctrl + Shift + D
顯示快捷鍵
?
增大字號
Ctrl + =
減小字號
Ctrl + -