//******************************************************************************
//  MSP-FET430P440 Demo - USART0, 2400 UART Ultra-low Pwr Echo ISR, 32kHz ACLK
//
//  Description: Echo a received character, RX ISR used. In the Mainloop UART0
//  is made ready to receive one character with interrupt active. The Mainloop
//  waits in LPM3. The UART0 ISR forces the Mainloop to exit LPM3 after
//  receiving one character which echo's back the received character.
//  Baud rate divider with 32768Hz XTAL @2400 = 32768/2400 = ~13.65 (00Dh|6Bh)
//  ACLK = LFXT1 = 32768Hz, MCLK = SMCLK = default DCO = 32 x ACLK = 1048576Hz
//  //* An external watch crystal between XIN & XOUT is required for ACLK *//	
//
//                MSP430F449
//             -----------------
//         /|\|              XIN|-
//          | |                 | 32kHz
//          --|RST          XOUT|-
//            |                 |
//            |             P2.4|----------->
//            |                 | 2400 - 8N1
//            |             P2.5|<-----------
//
//
//  M. Buccini / A. Dannenberg
//  Texas Instruments Inc.
//  May 2005
//  Built with Code Composer Essentials Version: 1.0
//*****************************************************************************
#include <msp430x44x.h>

void main(void)
{
  WDTCTL = WDTPW + WDTHOLD;                 // Stop WDT
  FLL_CTL0 |= XCAP18PF;                     // Configure load caps
  P2SEL |= 0x30;                            // P2.4,5 = USART0 TXD/RXD
  ME1 |= UTXE0 + URXE0;                     // Enable USART0 TXD/RXD
  UCTL0 |= CHAR;                            // 8-bit character
  UTCTL0 |= SSEL0;                          // UCLK = ACLK
  UBR00 = 0x0D;                             // 32k/2400 - 13.65
  UBR10 = 0x00;
  UMCTL0 = 0x6B;                            // Modulation
  UCTL0 &= ~SWRST;                          // Initialize USART state machine
  IE1 |= URXIE0;                            // Enable USART0 RX interrupt

  // Mainloop
  for (;;)
  {
    _BIS_SR(LPM3_bits + GIE);               // Enter LPM3 w/interrupt
    while (!(IFG1 & UTXIFG0));              // USART0 TX buffer ready?
    TXBUF0 = RXBUF0;                        // RXBUF0 to TXBUF0
  }
}

// UART0 RX ISR will for exit from LPM3 in Mainloop
__interrupt void usart0_rx (void);
USART0RX_ISR(usart0_rx)
__interrupt void usart0_rx (void)
{
  _BIC_SR_IRQ(LPM3_bits);                   // Clear LPM3 bits from 0(SR)
}