menu "Dallas's 1-wire bus"config W1	tristate "Dallas's 1-wire support"	---help---	  Dallas's 1-wire bus is usefull to connect slow 1-pin devices	  such as iButtons and thermal sensors.	  If you want W1 support, you should say Y here.	  This W1 support can also be built as a module.  If so, the module	  will be called wire.ko.config W1_MATROX	tristate "Matrox G400 transport layer for 1-wire"	depends on W1 && PCI	help	  Say Y here if you want to communicate with your 1-wire devices	  using Matrox's G400 GPIO pins.	  This support is also available as a module.  If so, the module	  will be called matrox_w1.ko.config W1_DS9490	tristate "DS9490R transport layer driver"	depends on W1 && USB	help	  Say Y here if you want to have a driver for DS9490R UWB <-> W1 bridge.	  This support is also available as a module.  If so, the module	  will be called ds9490r.ko.config W1_DS9490_BRIDGE	tristate "DS9490R USB <-> W1 transport layer for 1-wire"	depends on W1_DS9490	help	  Say Y here if you want to communicate with your 1-wire devices	  using DS9490R USB bridge.	  This support is also available as a module.  If so, the module	  will be called ds_w1_bridge.ko.config W1_THERM	tristate "Thermal family implementation"	depends on W1	help	  Say Y here if you want to connect 1-wire thermal sensors to you	  wire.config W1_SMEM	tristate "Simple 64bit memory family implementation"	depends on W1	help	  Say Y here if you want to connect 1-wire	  simple 64bit memory rom(ds2401/ds2411/ds1990*) to you wire.config W1_DS2433	tristate "4kb EEPROM family support (DS2433)"	depends on W1	help	  Say Y here if you want to use a 1-wire	  4kb EEPROM family device (DS2433).config W1_DS2433_CRC	bool "Protect DS2433 data with a CRC16"	depends on W1_DS2433	select CRC16	help	  Say Y here to protect DS2433 data with a CRC16.	  Each block has 30 bytes of data and a two byte CRC16.	  Full block writes are only allowed if the CRC is valid.endmenu