# ---------------------------------------------------------------------------------# --- OpenDMTP Client Property file# ---------------------------------------------------------------------------------# --- serial port device configuration# - GPRS modem serial port device (set to appropriate device)cfg.xpo.port=ttyS0cfg.xpo.debug=0# - GPS receiver serial port device (set to appropriate device)cfg.gps.port=ttyS1cfg.gps.debug=0# --- connection parameters# - maximum number of total connections, duplex connections, and time frame# - ("1,1,0" means "no maximum")com.maxconn=1,1,0# - absolute minimum time delay between transmissionscom.mindelay=60# - minimum time delay between transmissions for non-critical eventscom.minrate=60# - maximum number of events to send per block during Duplex transmissionscom.maxduplex=10# - maximum number of events to send per block during Simplex transmissions# - ("0" means never send data via "Simplex")com.maxsimplex=0# --- remote server/port# - change this to match the actual remote server name/portcom.host=myserver.example.comcom.port=31000# --- Wireless airtime service provider config# - set these to the values required by your aritime service providercom.apnname=proxycom.apnserv=proxy# --- motion configuration# - definition of start of motion (ie. 10.0 kph)mot.start=10.0# - seconds between in-motion messagesmot.inmotion=120# - definition of stop motion (ie. 300 seconds - 5 minutes)mot.stop=300# - definition of 'dormant' (non-motion) time (ie. 1800 seconds - 30 minute)mot.dorm.rate=1800# - how many 'dormant' messages to send (ie. 1 dormant message)mot.dorm.cnt=1# --- custom geozones# - set these to the radius, latitude, & longitude, for geozones for which# - you want arrival/departure messages generated.  The format is:# -    <MetersRadius>,<Latitude>,<Longitude># - (The current limit is 4 geozones) cst.geof.1=0,0.0,0.0cst.geof.2=cst.geof.3=cst.geof.4=# ---