## This file is used for selecting non-standard netcard options, and# need not be modified for typical use.## Drivers are *not* selected in this file, but rather with files# automatically generated during the top-level kernel configuration.## Special options supported, indexed by their 'config' name:##  CONFIG_WD80x3	The Western Digital (SMC) WD80x3 driver#	WD_SHMEM=xxx	Forces the address of the shared memory#	WD_no_mapout	Don't map out the shared memory (faster, but#			your machine may not warm-boot).#  CONFIG_NE2000	The NE-[12]000 clone driver.#	PACKETBUF_MEMSIZE  Allows an extra-large packet buffer to be#			used.  Usually pointless under Linux.#	show_all_SAPROM  Show the entire address PROM, not just the#			ethernet address, during boot.#	rw_bugfix	Patch an obscure bug with a version of the 8390.#  CONFIG_HPLAN		The HP-LAN driver (for 8390-based boards only).#	rw_bugfix	Fix the same obscure bug.#  CONFIG_EL2		The 3c503 EtherLink II driver#	EL2_AUI		Default to the AUI port instead of the BNC port#	no_probe_nonshared_memory  Don't probe for programmed-I/O boards.#	EL2MEMTEST	Test shared memory at boot-time.#  CONFIG_PLIP		The Crynwr-protocol PL/IP driver#	INITIALTIMEOUTFACTOR	Timing parameters.#	MAXTIMEOUTFACTOR#  D_LINK		The D-Link DE-600 Portable Ethernet Adaptor.#	  D_LINK_IO	The D-Link I/O address (0x378 == typical)#	  D_LINK_IRQ	The D-Link IRQ number to use (IRQ7 == typical)#	  D_LINK_DEBUG	Enable or disable D-Link debugging#  DEPCA		The DIGITAL series of AT Ethernet Cards (DE100, DE200)#	  DEPCA_IRQ	Set the desired IRQ (=0, for autoprobe)#	  DEPCA_DEBUG	Set the desired debug level## The following options exist, but cannot be set in this file.#  lance.c#	LANCE_DMA	Change the default DMA to other than DMA5.#  8390.c#	NO_PINGPONG	Disable ping-pong transmit buffers.# Most drivers also have a *_DEBUG setting that may be adjusted.# The 8390 drivers share the EI_DEBUG settting.# General options for Space.cOPTS		= # -DETH0_ADDR=0x300 -DETH0_IRQ=11WD_OPTS		= #-DWD_SHMEM=0xDD000EL2_OPTS	= #-DEL2_AUINE_OPTS		=HP_OPTS		=PLIP_OPTS	=DEPCA_OPTS	= -DDEPCA_IRQ=0 -DDEPCA_DEBUG=1# The following are the only parameters that must be set in this file.DL_OPTS		= -DD_LINK_IO=0x378 -DD_LINK_IRQ=7 -UD_LINK_DEBUG