README: vxWorks BSP for Intel's IXP425 Network processorThis file contains board-specific information for the IXDP425board.	This file documents BSP	interface changes from previoussoftware or hardware versions, and notifies the	user of	seriouscaveats	that must be noted before using	this BSP.  Additionally, thetarget board's reference entry (i.e. IXDP425/target.nr) providesboard-specific information necessary to	run VxWorks and	should be readfully before this BSP is used.------------------------------------------------------------------------RELEASE 1.2/10        Support for Intel Access Library 1.5  (This version of the BSP        will not work with access library version 1.4 and        previous).  The latest access library may be found at Intel's        developer website.        More accurate timer frequencies        BOOTP fix (SPR 96460)        Adjustments to SDRAM delay SPR 95737        diab compilation issues        Initialize ixEthDB feature earlierRELEASE 1.2/9        Support for Intel IxEthDB filtering        Fixed sysToMonitor warm reboots        Fixed auxClock to pass VTS        Increased maximum clock rates        Added fix for SPR 95737 (SDRAM command timing in romInit.s)RELEASE 1.2/8        netBufLib fixes for PNE router stack.        Support for Intel IXP400 software v1.4        EEPROM initialization for Redboot booting        Enable trapping of mis-aligned data        bootrom_uncmp now boots in little endian BSP        warmboot no longer causes data abort (Warmboot occurs        automatically when FTP cannot load the vxWorks file)RELEASE 1.2/7	Newly implemented little endian support requires Intel IXP400	software v1.3 and XSCALE pbit support.        Tornado 2.2.1 requires SPR 89608 patch to be installed for        little endian (pbit) support.  The patch may be installed from        target/config/ixdp425/patch-SPR89608.  Since this patch is        only valid for the Tornado 2.2.1 release (CP1), only big        endian builds can be supported under Tornado 2.2.0.        Diab compilation support was added for vxWorks images.  There        is currently a problem with bootrom images built with dcc        though.  Also, the default dcc compile flags are not designed        with optimization in mind.  It is possible that performance        might be improved with better use of diab optimization flags.        Implemented 2233 MIB in polled mode for better performance        when 2233 is enabled.  Note: If this must be built under        Tornado 2.2.0 (unpatched), then INCLUDE_RFC_2233 must be        undefined in config.h. 2233 MIB support fixes SNMP statistics        reporting issues.        LIB_EXTRA uses "+=" allowing command line builds to also use        the make variable.        The Intel Access Library name changed.  The access Library        versioning system changed.        Ixe devices are no longer initialized during warmboot when        removed from "other" field.	NVRAM FLASH support was added.        Removed compile warnings.RELEASE	1.3/3 or 1.2/3	Released from Wind River for Tornado 2.2 CP1. Version number	corrected to match WRS standard.        Various bug fixes for Ethernet, PCI, Timer, and Serial        devices.        Better throughput performance on the IXE ethernet devices. RELEASE	1.2/1	Initial release.