%CECan not reroute read-only feature.Can not reroute read-only feature.不能對只讀特征進行重定參照。%CECan not reroute this feature.Can not reroute this feature.不能對這一特征進行重定參照。%CEDatum surface aborted. Invalid control point found.Datum surface aborted. Invalid control point found.基準曲面失敗。發現無效的控制點。%CIFeature rerouted successfully.Feature rerouted successfully.特征重定參考成功。%CEFeature-reroute aborted.Feature-reroute aborted.特征重定參照中止。%CPSelect an alternate axis.Select an alternate axis.選取一個替代軸。%CPSelect an alternate coordinate system.Select an alternate coordinate system.選取一個替代坐標系。%CPSelect an alternate dimensioning reference.Select an alternate dimensioning reference.選取一個替代尺寸標注參照。%CPSelect an alternate edge.Select an alternate edge.選取一條替代邊。%CPSelect an alternate feature.Select an alternate feature.選取一個替代特征。%CPSelect an alternate horizontal reference plane for sketcher.Select an alternate horizontal reference plane for sketcher.為草繪器選取一個替代水平參照平面。%CPSelect an alternate point.Select an alternate point.選取一個替代點。%CPSelect an alternate reference.Select an alternate reference.選取一個替代參照。%CPSelect an alternate sketching plane.Select an alternate sketching plane.選取一個替代草繪平面。%CPSelect an alternate surface.Select an alternate surface.選取替代曲面。%CPSelect an alternate vertical reference plane for sketcher.Select an alternate vertical reference plane for sketcher.為草繪器選取一個替代垂直參照平面。%CPSelect feature to reroute.Select feature to reroute.選取特征重定參照。%CWWARNING: New reference is not coincident with the old one.WARNING: New reference is not coincident with the old one.警告: 新參考與原先的參考不重疊。%CWWARNING: Unable to check if new reference is coincident with the old one.WARNING: Unable to check if new reference is coincident with the old one.警告: 如果參考與原先的參考重疊則不能檢測。%CECan not reroute group pattern feature.Can not reroute group pattern feature.不能對組陣列特征進行重定參照。%CPSelect an alternate coordinate system from the external model.Select an alternate coordinate system from the external model.從外部模型中選取一個替代坐標系。%CPSelect or create an alternate coordinate system for the local model.Select or create an alternate coordinate system for the local model.為局部模型選取或創建一個替代坐標系。%CPSelect an alternate logical edge.Select an alternate Chain of Edges.選取一個替代邊鏈。%CPSelect an alternate logical surface.Select an alternate Set of Surfaces.選取一個替代曲面集。