# config file for the chg-multi tape changer program.# Used when tpchanger "chg-multi" is specified in amanda.conf.# chg-multi supports several configurations, with or without an actual # changer. Please see docs/TAPE.CHANGERS for a description## chg-multi should actually work directly with any changer that allows# access to the slots via Unix devices that look to software like# regular tape drives. (that is, you don't need a changer driver...).# Configuration variables:#  #  'multieject': use an 'mt offline' command to change to the next#    tape, or multiple such commands for skipping several tapes at a#    time. ##  'needeject': this option is incompatible with 'multieject'. This is #    needed for changers accessed through several virtual tape#    devices, when the changer needs the current tape to be ejected#    before changing to another device.##  'gravity': set this to 1 if the changer/stacker is unable to loop#    back to the first tape after unloading the last one, or if you#    don't want amanda to go through the tape stack looking for the#    exact tape it wants instead of using the first acceptable one.##  slot X: The configuration file should list as many 'slot X'#    statements as the number of slots supported by the changer or the #    number of separate tape drives used.# For changers that need an 'mt offline' to load the next tapemultieject 0# Is this a gravity stacker that can't go backwards or cycle ?  If# yes, set gravity to 1.gravity 0# Does this tape-changer need an explicit eject command before loading# a new tape?  If you are using multiple drives as a tape changer, you# don't want to do this, but if you are using an auto-changer that# allows access to the slots through Unix tape devices, it might block# the mount of a new slot until the old is explicitly ejected.  In# that case, set needeject to 1.needeject 0# On some machines there is a delay between when the eject command# finishes and the next tape is ready to be accessed.  Set ejectdelay# to the number of seconds to wait after an eject command. This will# almost certainly be needed if multieject is set, probably not if# needeject is used.ejectdelay 0# Names a status file where the current ``changer'' state is stored.statefile /usr/adm/amanda/csd/changer-status# What are the slot numbers used in the tape rack?firstslot 1lastslot 4# Enumerate the device files that go with the particular tape changer# slots. Don't forget to specify the no-rewind version of the device.slot 1 /dev/nrst8slot 2 /dev/nrst9slot 3 /dev/nrst10slot 4 /dev/nrst11