#define uchar      unsigned char
#define uint       unsigned int
#define ulong      unsigned long

#define OCM128_DIR   P4DIR
#define OCM128_OUT   P4OUT
#define OCM128_IN    P4IN
#define OCM128_R     P4REN
#define OCM128_SEL   P4SEL
#define OCM128_CS       0x80	 //CHIP ENABLE 
#define OCM128_RST      0x40	//Reset Signal 低電平有效
#define OCM128_AO       0x20	//H: DATA L: COMMAND 
#define OCM128_SCLK     0x10	//serial clock
#define OCM128_CDA      0x08	//SERIAL DATA INPUT 

#define GT_DIR   P1DIR
#define GT_OUT   P1OUT
#define GT_IN    P1IN
#define GT_R     P1REN
#define GT_SEL   P1SEL
#define GT_CS			0x01	 //CHIP ENABLE 
#define GT_SO			0x02	
#define GT_SI			0x04	
#define GT_SCLK			0x08	

#define LCD_BACK_PxOUT         P4OUT
#define LCD_BACK_PxDIR         P4DIR
#define LED_BACK             0x04

#define TI_CC_SW_PxIN           P1IN
#define TI_CC_SW_PxIE           P1IE
#define TI_CC_SW_PxIES          P1IES
#define TI_CC_SW_PxIFG          P1IFG

#define KEY_ESC    0x80               //INC鍵定義
#define KEY_UP    0x40               //FUN鍵定義
#define KEY_DOWN   0x20
#define KEY_OK    0x10               //DEC鍵定義

ulong get_chn16x16_addr_of_gt(uchar ,uchar );
ulong get_eng8x16_addr_of_gt(uchar );
ulong get_eng8x8_addr_of_gt(uchar );
void send_byte_to_gt(uchar );
uchar get_byte_from_gt(void);
void highspeed_readdata_from_gt(ulong ,uchar );
void delay_nus(uint );
void delay_n_ms(uint );
void serial_write(uchar );
void send_cmd(uchar );
void send_data(uchar );
void set_page_address(uchar );
void set_column_address(uchar );
void lcd_initial(void) ;
void disp_chinese(uchar *,uchar ,uchar ,uchar ,uchar ,uchar );
void disp_8x16character(uchar  *,uchar ,uchar ,uchar ,uchar,uchar );
void disp_8x8character(uchar  *,uchar ,uchar ,uchar ,uchar );
void disp_8x8character1(uchar  *,uchar ,uchar );
void disp_lattice(uchar ,uchar );
void disp_graphics(uchar *);