Analog to Digital Converter Example Program
===========================================
Project: ADC

This example program shows how to configure and use the 8 bit A/D 
Converter 8 channels of the following microcontroller:

   * Infineon C505-2R
   * Infineon C505-L
   * Infineon C505C-2R
   * Infineon C515-1R
   * Infineon C515-L
   * Infineon SAB 80C515
   * Infineon SAB 80C535

After configuring the A/D, the program reads all of the A/D Converter
channels and outputs the converted values using the serial port.

To run this program...

1. Select the device from the pull-down target list
2. Build the project (Project - Build Target)
3. Start the uVision Debugger
4. Open the Serial Window (View - Serial Window 1)
5. Open the Toolbox (View - Toolbox)
6. Click Go or Run (F5)
7. Click on the Toolbox buttons to change input voltages


A debug script (debug.ini) creates buttons that set different 
analog values in A/D channels.  As the program runs, you 
will see the A/D input and output change.

Other buttons create signals that generate sine wave 
or sawtooth patterns as analog inputs.  礦ision3 users may 
enable the built-in Logic Analyzer to view, measure and compare
these input signals graphically.