?? makefile
字號:
## for USB OTG silicon based on Mentor Graphics INVENTRA designs#musb_hdrc-objs := plat_uds.oobj-$(CONFIG_USB_MUSB_HDRC) += musb_hdrc.oifeq ($(CONFIG_ARCH_DAVINCI),y) musb_hdrc-objs += davinci.oendififeq ($(CONFIG_USB_TUSB6010),y) musb_hdrc-objs += tusb6010.oendififeq ($(CONFIG_ARCH_OMAP2430),y) musb_hdrc-objs += omap2430.oendififeq ($(CONFIG_ARCH_OMAP3430),y) musb_hdrc-objs += omap2430.oendififeq ($(CONFIG_USB_GADGET_MUSB_HDRC),y) musb_hdrc-objs += g_ep0.o musb_gadget.oendififeq ($(CONFIG_USB_MUSB_HDRC_HCD),y) musb_hdrc-objs += virthub.o musb_host.o musb_hset.oendififeq ($(CONFIG_PROC_FS),y) musb_hdrc-objs += musb_procfs.oendif# the kconfig must guarantee that only one of the# possible I/O schemes will be enabled at a time ...# PIO (INVENTRA_FIFO), or DMA (several potential schemes).# though PIO is always there to back up DMA, and for ep0ifneq ($(CONFIG_USB_INVENTRA_FIFO),y) ifeq ($(CONFIG_USB_INVENTRA_DMA),y) musb_hdrc-objs += musbhsdma.o else ifeq ($(CONFIG_USB_TI_CPPI_DMA),y) musb_hdrc-objs += cppi_dma.o else ifeq ($(CONFIG_USB_TUSB_OMAP_DMA),y) musb_hdrc-objs += tusb6010_omap.o endif endif endifendif################################################################################# FIXME remove all these extra "-DMUSB_* things, stick to CONFIG_*ifeq ($(CONFIG_USB_INVENTRA_MUSB_HAS_AHB_ID),y) EXTRA_CFLAGS += -DMUSB_AHB_IDendif# DebuggingMUSB_DEBUG:=$(CONFIG_USB_INVENTRA_HCD_LOGGING)ifeq ("$(strip $(MUSB_DEBUG))","") ifdef CONFIG_USB_DEBUG MUSB_DEBUG:=1 else MUSB_DEBUG:=0 endifendififneq ($(MUSB_DEBUG),0) EXTRA_CFLAGS += -DDEBUGendifEXTRA_CFLAGS += -DMUSB_DEBUG=$(MUSB_DEBUG)?? 快捷鍵說明
復制代碼
Ctrl + C
搜索代碼
Ctrl + F
全屏模式
F11
切換主題
Ctrl + Shift + D
顯示快捷鍵
?
增大字號
Ctrl + =
減小字號
Ctrl + -