function par = setpar% DESCRIPTION par = setpar%  Sets the structured parameter par that is the input to runef.%  This file is intended to use as a template. Rename and change%  its content to your desire.% OUTPUT      %  par --  input parameter to rune% TRY%  setpar% SEE ALSO%  runef% by Magnus Almgren 000530 par.cellradius = 1000; % cell radius [m] par.km = 1;            % km^2+lm^2+km*lm => the number of sites par.lm = 1;            % related to km above par.sps = 3;           % Number of sectors per site par.ncluster = 3;      % number of clusters equals ncluster^2 par.kpc = 2;           % number of allocated channels per cell par.gainconst = 21;    % gain at 1 meter distance  par.noise = -118;      % thermal noise floor -118 dBm par.alpha = 3.5;       % distance attenuation coefficient par.sigma = 6;         % standard deviation for the log-normal fading in dB par.raa = 0.5;         % lognormal correlation down link (typical 0.5) par.corrdist = 110;    % lognormal fading correlation distance [m] par.offtraf = 2;       % average number of offered calls to a cell      par.mht = 20;          % mean holding time [seconds]   par.amean = 1;         % mean acceleration [m/s/s] par.vmean = 14;        % mean speed  [m/s] par.pinit = 20;        % init power set to each new link par.sirmin = 10;       % C/I level under which a call is dropped   par.homargin = 3;      % gain margin between two bases used at Hand Off  par.dt = 1;            % time interval in the simulation loop par.maxiter = 10;      % number of iterations in the main loop  par.seed = 1;          % seed to all random sequencies in the simulation