if { [info exists CHIPNAME] } {	   set  _CHIPNAME $CHIPNAME    } else {	    set  _CHIPNAME lpc2148}if { [info exists ENDIAN] } {	   set  _ENDIAN $ENDIAN    } else {	    set  _ENDIAN little}if { [info exists CPUTAPID ] } {   set _CPUTAPID $CPUTAPID} else {  # force an error till we get a good number   set _CPUTAPID 0xffffffff}#delays on reset linesjtag_nsrst_delay 200jtag_ntrst_delay 200# NOTE!!! LPCs need reset pulled while RTCK is low. 0 to activate # JTAG, power-on reset is not enough, i.e. you need to perform a# reset before being able to talk to the LPC2148, attach is not# possible.#use combined on interfaces or targets that can't set TRST/SRST separatelyreset_config trst_and_srst srst_pulls_trst#jtag scan chainjtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPIDset _TARGETNAME [format "%s.cpu" $_CHIPNAME]target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi-s_r4$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0$_TARGETNAME configure -event reset-init {	# Force target into ARM state	soft_reset_halt	#do not remap 0x0000-0x0020 to anything but the flash	mwb 0xE01FC040 0x01 	}#flash bank lpc2000 <base> <size> 0 0 <target#> <variant>flash bank lpc2000 0x0 0x7d000 0 0 0 lpc2000_v2 14765