#start slow, speed up after resetjtag_khz 10if { [info exists CHIPNAME] } {	   set  _CHIPNAME $CHIPNAME    } else {	    set  _CHIPNAME str710}if { [info exists ENDIAN] } {	   set  _ENDIAN $ENDIAN    } else {	    set  _ENDIAN little}if { [info exists CPUTAPID] } {	   set  _CPUTAPID $CPUTAPID    } else {	    set  _CPUTAPID 0x3f0f0f0f}#use combined on interfaces or targets that can't set TRST/SRST separatelyreset_config trst_and_srst srst_pulls_trst#jtag scan chainjtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0x0f -expected-id $_CPUTAPIDset _TARGETNAME [format "%s.cpu" $_CHIPNAME]target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi$_TARGETNAME configure -event reset-start { jtag_khz 10 }$_TARGETNAME configure -event reset-init { jtag_khz 6000 }$_TARGETNAME configure -event gdb-flash-erase-start {	flash protect 0 0 7 off	flash protect 1 0 1 off}$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x2000C000 -work-area-size 0x4000 -work-area-backup 0#flash bank str7x <base> <size> 0 0 <target#> <variant>flash bank str7x 0x40000000 0x00040000 0 0 0 STR71xflash bank str7x 0x400C0000 0x00004000 0 0 0 STR71x# For more information about the configuration files, take a look at:# openocd.texi