//******************************************************************************
//  MSP-FET430P410 Demo - FLL+, LPM3 Using Basic Timer ISR, 32kHz ACLK
//
//  Description: System runs normally in LPM3 with basic timer clocked by
//  32kHz ACLK. At a 2 second interval the basic timer ISR will wake the
//  system and flash the LED on P5.1 inside of the Mainloop.
//  ACLK = LFXT1 = 32768, MCLK = SMCLK = DCO = 32xACLK = 1.048576MHz
//  //*External watch crystal on XIN XOUT is required for ACLK*//	
//
//
//            MSP430F413
//         ---------------
//     /|\|            XIN|-
//      | |               | 32kHz
//      --|RST        XOUT|-
//        |               |
//        |           P5.1|-->LED
//
//  M. Buccini
//  Texas Instruments Inc.
//  Feb 2005
//  Built with CCE Version: 3.2.0 and IAR Embedded Workbench Version: 3.21A
//*****************************************************************************
#include  <msp430x41x.h>

void main(void)
{
  WDTCTL = WDTPW + WDTHOLD;                 // Stop WDT
  FLL_CTL0 |= XCAP14PF;                     // Configure load caps
  IE2 |= BTIE;                              // Enable BT interrupt
  BTCTL = BTDIV+BTIP2+BTIP1+BTIP0;          // 2s Interrupt
  P1DIR = 0xFF;                             // All P1.x outputs
  P1OUT = 0;                                // All P1.x reset
  P2DIR = 0xFF;                             // All P2.x outputs
  P2OUT = 0;                                // All P2.x reset
  P3DIR = 0xFF;                             // All P3.x outputs
  P3OUT = 0;                                // All P3.x reset
  P4DIR = 0xFF;                             // All P4.x outputs
  P4OUT = 0;                                // All P4.x reset
  P5DIR = 0xFF;                             // All P5.x outputs
  P5OUT = 0;                                // All P5.x reset
  P6DIR = 0xFF;                             // All P6.x outputs
  P6OUT = 0;                                // All P6.x reset

  while(1)
  {
    int i;
    _BIS_SR(LPM3_bits + GIE);               // Enter LPM3 w/ interrupts
    P5OUT |= 0x02;                          // Set P5.1 LED on
    for (i = 5000; i>0; i--);               // Delay
    P5OUT &= ~0x02;                         // Clear P5.1 LED off
  }
}

// Basic Timer interrupt service routine
#pragma vector=BASICTIMER_VECTOR
__interrupt void basic_timer(void)
{
    _BIC_SR_IRQ(LPM3_bits);             // Clear LPM3 bits from 0(SR)
}