## Acorn Network device configuration#  These are for Acorn's Expansion card network interfaces#config ARM_AM79C961A	bool "ARM EBSA110 AM79C961A support"	depends on NET_ETHERNET && ARM && ARCH_EBSA110	select CRC32	help	  If you wish to compile a kernel for the EBSA-110, then you should	  always answer Y to this.config ARM_ETHER1	tristate "Acorn Ether1 support"	depends on NET_ETHERNET && ARM && ARCH_ACORN	help	  If you have an Acorn system with one of these (AKA25) network cards,	  you should say Y to this option if you wish to use it with Linux.config ARM_ETHER3	tristate "Acorn/ANT Ether3 support"	depends on NET_ETHERNET && ARM && ARCH_ACORN	help	  If you have an Acorn system with one of these network cards, you	  should say Y to this option if you wish to use it with Linux.config ARM_ETHERH	tristate "I-cubed EtherH/ANT EtherM support"	depends on NET_ETHERNET && ARM && ARCH_ACORN	select CRC32	help	  If you have an Acorn system with one of these network cards, you	  should say Y to this option if you wish to use it with Linux.config ARM_ETHER00	tristate "Altera Ether00 support"	depends on NET_ETHERNET && ARM && ARCH_CAMELOT	help	  This is the driver for Altera's ether00 ethernet mac IP core. Say	  Y here if you want to build support for this into the kernel. It	  is also available as a module (say M here) that can be inserted/	  removed from the kernel at the same time as the PLD is configured.	  If this driver is running on an epxa10 development board then it	  will generate a suitable hw address based on the board serial	  number (MTD support is required for this). Otherwise you will	  need to set a suitable hw address using ifconfig.config ARM_CS8900    tristate "CS8900 support"	depends on NET_ETHERNET && ARM && ARCH_SMDK2410	help	  Support for CS8900A chipset based Ethernet cards. If you have a	  network (Ethernet) card of this type, say Y and read the	  Ethernet-HOWTO, available from 	  <http://www.tldp.org/docs.html#howto> as well as 	  <file:Documentation/networking/cs89x0.txt>.      	  To compile this driver as a module, choose M here and read	  <file:Documentation/networking/net-modules.txt>.  The module will be	  called cs8900.o.