This file documents changes in the software, firmware and hardware of theAVR-Doper project. New entries are always appended to the end of the file.Scroll down to the bottom to see the most recent changes.* Release 2006-07-18- Added compatibility macros to allow ATMega88 instead of ATMega8.- Ignore synchLoops parameter in ISP mode since avrdude sometimes sends 0.- Changed default ISP clock speed to 2 (instead of fastest).* Release 2006-09-12- Added patch for avrdude to support HID mode.- Updated Readme file with information about HID mode and avrdude.* Release 2006-10-23- Fixed bug in ISP value polling. Value polling is used when programming older  devices such as the AT90S8515.* Release 2007-02-01- Updated to newest AVR-USB driver version.- Connected pins 2 and 3 of 8 pin programming socket because these pins are  swapped on some devices.- License is now GPL2* Release 2007-03-29- Insert "Load Extended Address" command when bit 31 of address is set.- avrdebug accepts keyboard input now.- avrdebug works in HID mode and CDC mode now.* Release 2007-08-07- Fixed serious bug in SPI-MULTI command. When reading fuses, AVR-Doper sent  256 uninitialized bytes (content of last buffer) to the device which could  have unpredictable effects (including chip erase or similar nasty things).- Fixed bug in HVSP circuit: 14 pin socket must connect pins 11, 12 and 13 to  GND in order to enter HVSP mode.- Updated to new USB driver.* Release 2007-12-01- Added avrdoper-vista.inf file for Windows Vista.- Switched back to old hvspEnterProgmode() routine -- seems to work more  reliably than the one described in the ATTiny45 data sheet.* Release 2008-02-05- Assigned a serial number -- this should help to assign a consistent COM  device regardless of the USB port used.- Reworked ISP clock delay function so that it never goes below the given  delay.- Moved evaluation of received data into main loop. This reduces load  produced by USB interrupt slightly, since an ACK can be sent while commands  are executed.- Added -DMETABOARD_HARDWARE=1 option for programmers based on Metaboard  (see http://www.obdev.at/goto.php?t=metaboard-prog).- Added -DUSBASP_HARDWARE=1 option to provide alternative firmware for  Thomas Fischl's USBasp hardware (see http://www.fischl.de/usbasp/). - Reduced interrupt-disabled section in timer interrupt.- Image formats of schematics and board are now generated automatically from  EAGLE design.* Release 2008-04-26- Previous release introduced a bug on AVR-Doper hardware: LED was not  configured as output. Fixed.* Release 2008-04-27- Fixed report ID for debug data HID interface. This interface is not in use  because no host side driver exists (yet).- Fixed interface detection for Metaboard/USBasp hardware.- Don't configure Timer 1 for USBasp hardware.* Release 2008-11-27