Brutus is an evaluation platform for the SA1100 manufactured by Intel.  For more details, see:http://developer.intel.com/design/strong/applnots/sa1100lx/getstart.htmTo compile for Brutus, you must issue the following commands:	make brutus_config	make config	[accept all the defaults]	make dep	make zImageThe resulting kernel will end up in linux/arch/arm/boot/zImage.  This filemust be loaded at 0xc0008000 in Brutus's memory and execution started at0xc0008000 as well with the value of registers r0 = 0 and r1 = 16 uponentry.But prior to execute the kernel, a ramdisk image must also be loaded inmemory.  Use memory address 0xd8000000 for this.  Note that the file containing the (compressed) ramdisk image must not exceed 4 MB.Typically, you'll need angelboot to load the kernel.The following angelboot.opt file should be used:----- begin angelboot.opt -----base 0xc0008000entry 0xc0008000r0 0x00000000r1 0x00000010device /dev/ttyS0options "9600 8N1"baud 115200otherfile ramdisk_img.gzotherbase 0xd8000000----- end angelboot.opt -----Then load the kernel and ramdisk with:	angelboot -f angelboot.opt zImageThe first Brutus serial port (assumed to be linked to /dev/ttyS0 on yourhost PC) is used by angel to load the kernel and ramdisk image. The serialconsole is provided through the second Brutus serial port. To access it,you may use minicom configured with /dev/ttyS1, 9600 baud, 8N1, no flowcontrol.Currently supported:	- RS232 serial ports	- audio output	- LCD screen	- keyboard	The actual Brutus support may not be complete without extra patches. If such patches exist, they should be found from ftp.netwinder.org/users/n/nico.A full PCMCIA support is still missing, although it's possible to hacksome drivers in order to drive already inserted cards at boot time withlittle modifications.Any contribution is welcome.Please send patches to nico@cam.orgHave Fun !