Analog to Digital Converter Example Program
===========================================
Project: ADC Converter
Author:  Kevin Bernhardt

This example program shows how to configure and use the
A/D Converter of the following microcontroller:

* ST ST10F269 

After configuring the A/D Converter, the program reads
A/D channel 0 and outputs the converted value using the serial port.

To run this program...

1. Build the project (Project Menu, Build Target)
2. Start the debugger (Debug Menu, Start/Stop Debug Session)
3. View the Serial Window (View Menu, Serial Window #1)
4. View the A/D converter peripheral (Peripheral Menu, A/D Converter)
5. Run the program (Debug Menu, Go)

A debug script (debug.ini) creates buttons that set different analog values
in each A/D channel.  As the program runs, you will see the A/D input change.

Another button runs a signal function that generates a sine wave on analog 
input 0.  礦ision3 users may enable the built-in Logic Analyzer to view, 
measure and compare the input and output signals graphically.