//-----------------------------------------------------------
//程序由AVR輔助開發工具V2.0.3自動生成     
//MCU系統的處理器為：    ATMega64
//MCU系統的晶振頻率：    7.3728 Mhz
//-----------------------------------------------------------

#include <iom64v.h>
#include "uart.h"

unsigned char rx0_buff = 0;       //串口0接收中斷緩沖區

//-----------------------------------------------------------
//串口0初始化子程序
//字符長度：8位
//奇偶校驗：禁止
//通訊模式：異步
//-----------------------------------------------------------
void Uart0_Init(void)
{
    UCSR0B  =  0x00;     //disable while setting baud rate
    UCSR0A  =  0x02;     //Bit1為1則倍速發送
    UCSR0C  =  0x0E;  
    UBRR0L  =  0x5F;     //波特率：9600 Bps
    UBRR0H  =  0x00;     //誤差率：0.000%
    UCSR0B  =  0x98;  
}

//-----------------------------------------------------------
//串口0接收中斷子程序
//-----------------------------------------------------------
#pragma interrupt_handler Uart0_Rx_Isr:iv_USART0_RX
void Uart0_Rx_Isr(void)
{
//uart has received a character in UDR0
//   unsigned char c;
   rx0_buff = UDR0;
}

//-----------------------------------------------------------
//串口0發送字節子程序
//-----------------------------------------------------------
void Putchar0(unsigned char c)
{
   while (!(UCSR0A&(1<<UDRE0)));
   UDR0=c;
}

//-----------------------------------------------------------
//串口0發送字符串子程序
//-----------------------------------------------------------
void Putstr0(char *s)
{
   while (*s)
   {
      Putchar0(*s);
      s++;
   }
}

//-----------------------------------------------------------
//串口0發送字符串子程序(帶有換行符)
//-----------------------------------------------------------
void Puts0(char *s)
{
   while (*s)
   {
      Putchar0(*s);
      s++;
   }
   Putchar0(0x0d);   //回車換行
   Putchar0(0x0a);
}